Installing the camera on the ceiling
Before installation, you have to be familiar with the above cautions and fill in the holes that are not used for installation.
To install your camera bottom on a pipe
1.Attach the provided template to the place to be installed and penetrate a hole (5mm diameter, minimum depth 35mm) for fixing your camera to insert the provided plastic anchor (HUD 5) to the full.
2.After connecting both power and video cables, put them in order not to have damage during installation.
3.Remove the Dome cover. For more information, see step 2 in “To install your camera bottom on a pipe” on page 13.
4.Install your camera. After aligning the hole where the plastic anchor is inserted with the camera installation hole, make tight four ASSY
5.Adjust the camera lens direction. For more information, see page 17, “Adjusting the camera direction.”
6.Attach the Dome cover. For more information, see step 3 in “To install your camera bottom on a pipe” on page 13.
In case of wiring after penetrating a hole on the installation site
1Penetrate a wiring hole toward the pipe. (Recommended hole size: within 30mm diameter)
2Attach the gasket on the bottom of the product as shown below. You have to correctly align the hole with the pipe hole.
If the hole deviates from the gasket, water leak may happen.
Gasket
ENG
15 