AT&T 8110, 8102 user manual Wall Installation, Rotating the Handset Tab

Page 17

Wall Installation

Use the following directions to mount the telephone on a standard wallphone jack with mounting studs.

1You must reverse the handset tab (which holds the handset when you hang up). See Figure 5.

●Hold down the switchhook and slide the tab up and out of its slot.

●Turn the tab so that the curved end is facing up.

●Insert the tab back into its slot.

b. Release and

remove handset

a. Handset retainerretainer. in place

c. Rotate handset	d. Replace handset
retainer 180 degrees.	retainer.

180°

FIGURE 5 Rotating the Handset Tab

14

Image 17

Contents AT&T Trademarks Contents Use Important Safety InstructionsService Emploi Consignes DE Securite ImportantesEntretien Conservez CES InstructionsAppendix B Your 8102 and 8110 TelephonesPage TOP View 8110 Telephone Top, Side, and Bottom Views Auto Answer button On the 8110 only Handset Adjunct equipment jack On the 8102 onlyProgram button Tone Selector Fast or Slow Ringer Volume controlFlash button Line jack Table/Desk Installation Installing Your TelephoneHandset cord jack Handset jack Rotating the Handset Tab Wall InstallationTriangle Mounting studs Base Base Locking Tab Voice Terminal Wall Labeling the Programmable Dialing Button Designation Card Using the FeaturesRemoving and Covering the Auto Answer Button Page Answering and Placing a Call Using the FeaturesTo end a call To place a call using the speakerphone for 8110 usersTo have your telephone automatically answer a call To turn off the Auto Answer featureAuto Answer for 8110 Users Hold FlashTo put a call on hold To return to the held callMute for 8110 Users MessageProgrammable Dialing Buttons Personalized RingProgrammable Dialing Buttons To erase a number stored on a programmable dialing button Redial With Auto-PauseTo dial a number with a programmable dialing button To program an automatic pause for redialed numbers To erase ALL stored access codesTo place/answer a call without lifting the handset Speakerphone for 8110 UsersTo prevent other party from hearing you To mute microphone To change from speakerphone to handsetAppendix a Page Answering Calls Appendix BOriginating Calls Putting Calls on HoldSwitching from the Headset to the Handset Appendix C Auxiliary Power for the 8110 TelephoneIf Your Telephone Does Not Respond Appendix DConnection and USE with the Nationwide Telephone Network FCC Registration and Repair InformationRight of the Telephone Company Interference InformationAT&T Warranty Information Dialing Numbers in Memory Storing Numbers in MemoryErasing a Number in Memory Holding and Returning to a CallUsing the Auto Answer Feature For 8110 Users Only Using the Built-in Speakerphone For 8110 Users OnlyComcode 555-015-131 Graphics AT&T Issue 2, March

Related manuals

Manual 4 pages 29.68 Kb