AT&T 8110, 8102 user manual Installing Your Telephone, Table/Desk Installation

Page 15

Installing Your Telephone

Note: Although the drawings in this section show an 8110 telephone, the following installation procedures are applicable for both the 8102 and the 8110 telephones.

Table/Desk Installation

Use the 7-foot straight line cord that came with your telephone to connect the telephone to a modular jack.

WARNING: Do not plug the handset cord into the line jack or the adjunct jack on the bottom of your telephone since it could damage your handset and the telephone.

1Turn the telephone upside down so that you can see the bottom of the telephone.

2Plug one end of the line cord into the line jack on the bottom of the telephone. See Figure 3 for the location of the line jack.

3Feed the line cord through the line cord routing channel. See Figure 3.

Line cord routing channel Line jack

BOTTOM VIEW

FIGURE 3 The Location of the Line Jack and Routing Channel

12

Image 15

Contents AT&T Trademarks Contents Use Important Safety InstructionsService Emploi Consignes DE Securite ImportantesEntretien Conservez CES InstructionsAppendix B Your 8102 and 8110 TelephonesPage TOP View 8110 Telephone Top, Side, and Bottom Views Auto Answer button On the 8110 only Handset Adjunct equipment jack On the 8102 onlyTone Selector Fast or Slow Ringer Volume control Flash buttonProgram button Line jack Table/Desk Installation Installing Your TelephoneHandset cord jack Handset jack Rotating the Handset Tab Wall InstallationTriangle Mounting studs Base Base Locking Tab Voice Terminal Wall Labeling the Programmable Dialing Button Designation Card Using the FeaturesRemoving and Covering the Auto Answer Button Page Answering and Placing a Call Using the FeaturesTo end a call To place a call using the speakerphone for 8110 usersTo turn off the Auto Answer feature Auto Answer for 8110 UsersTo have your telephone automatically answer a call To return to the held call FlashHold To put a call on holdMute for 8110 Users MessageProgrammable Dialing Buttons Personalized RingProgrammable Dialing Buttons Redial With Auto-Pause To dial a number with a programmable dialing buttonTo erase a number stored on a programmable dialing button To program an automatic pause for redialed numbers To erase ALL stored access codesTo change from speakerphone to handset Speakerphone for 8110 UsersTo place/answer a call without lifting the handset To prevent other party from hearing you To mute microphoneAppendix a Page Putting Calls on Hold Appendix BAnswering Calls Originating CallsSwitching from the Headset to the Handset Appendix C Auxiliary Power for the 8110 TelephoneIf Your Telephone Does Not Respond Appendix DConnection and USE with the Nationwide Telephone Network FCC Registration and Repair InformationRight of the Telephone Company Interference InformationAT&T Warranty Information Holding and Returning to a Call Storing Numbers in MemoryDialing Numbers in Memory Erasing a Number in MemoryUsing the Auto Answer Feature For 8110 Users Only Using the Built-in Speakerphone For 8110 Users OnlyComcode 555-015-131 Graphics AT&T Issue 2, March

Related manuals

Manual 4 pages 29.68 Kb