AT&T 8102 Auto Answer for 8110 Users, To have your telephone automatically answer a call

Page 26

Spkr ] to end call

Auto Answer (for 8110 Users)

Automatically answers the call and turns on the built-in speakerphone on the 8110 telephone. When this feature is activated, the telephone rings once, and then an alerter tone sounds to notify you that the call has been answered. Your telephone will automatically drop the call and be ready for the next call when the calling party hangs up.

Note: If you are using the 8110 telephone with a System 85 or a DEFINITY Generic 2 switch, the line must be assigned as "Data Restricted" in order for the telephone to work properly. Please contact your System Administrator to have this feature assigned to your line.

To have your telephone automatically answer a call

1While handset is on-hook, press [ Auto ]

●Button released to the "up" position

●Colored area on bottom of button reminds you that Auto Answer feature is active

2When a call comes in, the built-in speakerphone on your telephone is automatically activated

3

4

●Both you and the other party hear a full ring and then a short burst of tone

●Red light next to [ Spkr ] goes on

Speak to caller

When caller ends the call, 8110 telephone hangs up automatically or

You can press [

●The 8110 telephone is now ready for next Auto Answer call

To turn off the Auto Answer feature

1Press [ Auto ]

● Button reverts to "down" position

23

Image 26

Contents AT&T Trademarks Contents Important Safety Instructions UseService Consignes DE Securite Importantes EmploiConservez CES Instructions EntretienYour 8102 and 8110 Telephones Appendix BPage TOP View 8110 Telephone Top, Side, and Bottom Views Handset Adjunct equipment jack On the 8102 only Auto Answer button On the 8110 onlyProgram button Tone Selector Fast or Slow Ringer Volume controlFlash button Line jack Installing Your Telephone Table/Desk InstallationHandset cord jack Handset jack Wall Installation Rotating the Handset TabTriangle Mounting studs Base Base Locking Tab Voice Terminal Wall Using the Features Labeling the Programmable Dialing Button Designation CardRemoving and Covering the Auto Answer Button Page Using the Features Answering and Placing a CallTo place a call using the speakerphone for 8110 users To end a callTo have your telephone automatically answer a call To turn off the Auto Answer featureAuto Answer for 8110 Users To put a call on hold FlashHold To return to the held callMessage Mute for 8110 UsersPersonalized Ring Programmable Dialing ButtonsProgrammable Dialing Buttons To erase a number stored on a programmable dialing button Redial With Auto-PauseTo dial a number with a programmable dialing button To erase ALL stored access codes To program an automatic pause for redialed numbersTo prevent other party from hearing you To mute microphone Speakerphone for 8110 UsersTo place/answer a call without lifting the handset To change from speakerphone to handsetAppendix a Page Originating Calls Appendix BAnswering Calls Putting Calls on HoldSwitching from the Headset to the Handset Auxiliary Power for the 8110 Telephone Appendix CAppendix D If Your Telephone Does Not RespondFCC Registration and Repair Information Connection and USE with the Nationwide Telephone NetworkInterference Information Right of the Telephone CompanyAT&T Warranty Information Erasing a Number in Memory Storing Numbers in MemoryDialing Numbers in Memory Holding and Returning to a CallUsing the Built-in Speakerphone For 8110 Users Only Using the Auto Answer Feature For 8110 Users OnlyComcode 555-015-131 Graphics AT&T Issue 2, March

Related manuals

Manual 4 pages 29.68 Kb