AT&T 8110, 8102 Labeling the Programmable Dialing Button Designation Card, Using the Features

Page 21

Labeling the Programmable Dialing Button Designation Card

Use the following directions for labeling and inserting the programmable dialing buttons designation card on your telephone.

Note: For directions on storing numbers on the programmable dialing buttons, refer to "Programmable Dialing Buttons" in the section titled

Using the Features.

1In the blank space next to the appropriate Programmable Dialing button, write or type the name, telephone number, or dialed feature that you want to store there.

2

3

Fold along the perforated edge(s) and detach the card(s) from the sheet.

Remove the plastic cover by placing your finger in the finger slot on the right side of the telephone and lifting up.

4Place the designation card on the telephone. Replace the plastic cover over the designation card by fitting the cover's bottom tabs into the slots on the telephone and pressing down, allowing the tabs on the top to snap into place. See Figure 10.

FIGURE 10 Removing the Plastic Cover; Installing the Button Designation Card

18

Image 21

Contents AT&T Trademarks Contents Use Important Safety InstructionsService Emploi Consignes DE Securite ImportantesEntretien Conservez CES InstructionsAppendix B Your 8102 and 8110 TelephonesPage TOP View 8110 Telephone Top, Side, and Bottom Views Auto Answer button On the 8110 only Handset Adjunct equipment jack On the 8102 onlyTone Selector Fast or Slow Ringer Volume control Flash buttonProgram button Line jack Table/Desk Installation Installing Your TelephoneHandset cord jack Handset jack Rotating the Handset Tab Wall InstallationTriangle Mounting studs Base Base Locking Tab Voice Terminal Wall Labeling the Programmable Dialing Button Designation Card Using the FeaturesRemoving and Covering the Auto Answer Button Page Answering and Placing a Call Using the FeaturesTo end a call To place a call using the speakerphone for 8110 usersTo turn off the Auto Answer feature Auto Answer for 8110 UsersTo have your telephone automatically answer a call Hold FlashTo put a call on hold To return to the held callMute for 8110 Users MessageProgrammable Dialing Buttons Personalized RingProgrammable Dialing Buttons Redial With Auto-Pause To dial a number with a programmable dialing buttonTo erase a number stored on a programmable dialing button To program an automatic pause for redialed numbers To erase ALL stored access codesTo place/answer a call without lifting the handset Speakerphone for 8110 UsersTo prevent other party from hearing you To mute microphone To change from speakerphone to handsetAppendix a Page Answering Calls Appendix BOriginating Calls Putting Calls on HoldSwitching from the Headset to the Handset Appendix C Auxiliary Power for the 8110 TelephoneIf Your Telephone Does Not Respond Appendix DConnection and USE with the Nationwide Telephone Network FCC Registration and Repair InformationRight of the Telephone Company Interference InformationAT&T Warranty Information Dialing Numbers in Memory Storing Numbers in MemoryErasing a Number in Memory Holding and Returning to a CallUsing the Auto Answer Feature For 8110 Users Only Using the Built-in Speakerphone For 8110 Users OnlyComcode 555-015-131 Graphics AT&T Issue 2, March

Related manuals

Manual 4 pages 29.68 Kb