3Com FlexWATCH 3110 user manual ‘Save IP Address’ Button, ‘Go to Home Page’ Button

Network Video Server		User’s Manual
	IP Address	Input an IP address to be assigned to
		FlexWATCHTM server
		Note that the IP must be directly connectable
		with user’s PC. The above IP ’10.10.225.100’ is
		only an example.
C	IP, Subnet, Gateway	Whether to change IP, Subnet and Gate or IP and
		Subnet mask only.
D	‘Set IP Address’ Button	To activate a new IP assignment, click this
		button.
E	‘Save IP Address’ Button	To save IP-Address in the Flash Memory.
F	‘Go to Home Page’ Button	To launch FlexWATCH Web browser and start
		other configuration through Administration page.
G	‘Telnet to System’ Button	To guide you Telnet mode for Advanced
		Configuration.
H	Result window	Show the result of IP assignment. If failed, try
		again from the start or use other configuration
		method

3)	Input the Serial No. (MAC address) and Select “LAN Port”.
4)	Input the IP address, which will be assigned to the system.
5)	Click “Set IP Address” button to save the above configuration.
6)	Check whether message type is correctly appeared on Result window as below.
		------------ Set Server IP Address ------------
		ARP: Adding static entry to ARP table	[	OK	]
		Ping: Trying ping 10.10.225.100	[	OK	]
		ARP: Deleting static entry from ARP table	[	OK	]
7)	If message come up as below, IP address setting has been failed.
		------------ Set Server IP Address ------------
		ARP: Adding static entry to ARP table	[	OK	]
		Ping: Trying ping 10.10.225.100	[FAILED]
		Please check whether IP address and MAC address is
		valid.
		Then, please retry again.
		ARP: Deleting static entry from ARP table	[	OK	]

-If IP address setting is failed, please check whether correct IP/MAC address is entered. And try again with correct IP/MAC address, or please use HyperTerminal method.

-If the above result is O.K., follow the next step to finish Network Configuration.

27 Seyeon Tech Co., Ltd

- INTPLUS [2005] -