3Com FlexWATCH 3110 user manual Video Motion Detection, Setting procedure

Network Video Server User’s Manual

displayed.

Video Source: color and Gray mode option

Image Quality: 5 quality levels - highest, high, normal, low, lowest

)Note

Please note that if you increase image size and quality, actual JPEG file size will be increased and this may affect actual transmission frame rate. Thus, you are required to check out your network bandwidth available for FlexWATCHTM server and select the right size and quality of video.

Motion Detection : Refer to description about Motion detection feature below.

Time stamp : Date and Time information can be engraved in the JPEG Image. It is recommended to use time stamp only when you need image with built-in time info.

)Note that once Time stamp is enabled, over all transmission speed can be degraded.

3.3Video Motion Detection

Built-in motion detection function is supported by the FlexWATCHTM server so that server can sense the motion in the picture and trigger any services such as e-mail, FTP or alarm buffering services.

Up to 144 square blocks can be configured as a motion area so that you can flexibly filter out motion area.

3.3.1Setting procedure

1)Go to “Camera & Motion” option in the Admin Menu

2)Select the camera for video configuration

3)Click “Select Area” button from the Camera configuration menu

4)Click the square block to set up motion detection area

5)Adjust Motion sensitivity (the lower the number, the higher the motion sensitivity)

6)Check “Motion Enable” check box and Click “Apply” button to save your configuration

40 Seyeon Tech Co., Ltd

- INTPLUS [2005] -