Pioneer S-HTD510, XV-HTD510 Resetting the system, Switching the demo mode on/off

Page 45

Additional Information

11

Problem

Remedy

Noticeable difference in DVD

• DVDs and CDs use different recording methods. This is not a malfunction.

and CD volume.

 

 

 

 

 

Tuner

 

Noisy radio reception

• Check that the frequency is correct.

 

• Check that the antennas are connected properly. For FM, make sure that the antenna

 

is fully extended and positioned to give the best reception.

 

For AM, make sure that the loop antenna is pointing in the best direction.

 

• If the radio signal is weak, an outdoor antenna will usually give better results than the

 

supplied indoor types.

 

• Other electrical equipment, such as TVs, fluorescent lamps and motors can cause

 

interference. Try switching off or moving the equipment, or moving the antenna(s).

 

• The tuning interval may be incorrect for your country or region. Try switching the

 

tuning interval (page 41).

 

 

Auto tuning does not pick up some stations.

•Auto tuning will only detect radio stations with a good signal. For more sensitive tuning, connect an outdoor antenna.

General

 

 

The remote control doesn't

•

Make sure that you’re using the remote within its operating range and that there are

seem to work.

no obstacles between the remote and the sensor on the main unit.

 

•

Check that the batteries are not exhausted.

 

 

 

No audio, or audio is dis- torted.

•Check that the correct function is selected (DVD/CD, etc.), the volume turned up.

•Check that the MUTE function is not on and that the disc is not paused.

•Check that the disc is clean and undamaged (page 41-42).

•Check that all rear panel connections are correct.

•If you find dirty or oxidized plugs/terminals, clean them.

Can’t adjust sound mode

• The Record Mode is switched on. Switch off then adjust as desired (see page 25).

settings (bass, treble, etc.)

 

 

 

Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplug the power cord and then plug back in. This will usually reset the unit for proper operation. If this does not correct the problem, please consult your nearest Pioneer service center.

Resetting the system

Resetting the system returns all menu, picture and password settings to their factory defaults.

1Switch the system into standby using the front panel standby/on switch.

2Hold down the front panel 7 button and switch back on.

Switching the demo mode on/off

When you first plug in this system the display shows a demo sequence. The demo will also start if the system is on in the DVD function but idle for more than 5 minutes. The demo will stop if you press any button except CD MODE on the main unit .

•To switch the demo mode off completely, press and hold CD MODE on the main unit for about 3 seconds while the demo is in progress.

•To switch the demo mode on, press and hold CD MODE on the main unit for about 3 seconds while the system is in standby.

45

En

Page 44 Page 46
Image 45
Page 44 Page 46
Contents XV-HTD510 Important Notice Important Safety Instructions We Want You Listening ForALifetime Contents Using this manual FeaturesGraphical Setup Navigator Before You StartHints on installation Putting the batteries in the remote controlUsing the remote control Keep in mind the following when using the remote controlMoving the system Avoiding problems with condensationDVD Video compatibility Audio CD compatibilityConnecting Up Connecting the speakersRelease the speaker terminal tabs to secure Speaker cable Wall mounting the rear speaker system Placing the speakers3m 6-9ft. apart Before mountingVideo cord not supplied Connecting to your TVConnecting external antennas Connecting the supplied antennasConnecting the power Connecting other componentsControls & Displays Remote controlDisplay Front panelSetting up for surround sound Setting UpSwitching on and setting the clock Setting the speaker distancesPress Surround Mode Press 3 to move on to the Surround speakers settingBalancing the surround sound Press Enter to exitUsing the Setup Navigator Playing DVDs, CDs and Video CDs Getting StartedBasic playback controls Do not rotate the disc tray by hand. Always use ButtonNavigating Video CD PBC menus Navigating DVD disc menusExchanging discs Listening to the radioListening to station presets Saving station presetsListening to other components Improving FM stereo soundAdjusting the bass and treble Using Surround SoundUsing sound modes Using P.BassPress DSP to select a sound mode Adjusting the effect levelListening to other sources with room effects HallDirect recording Listening at low volumePress Sound Use the 2 or 3 buttons to select Use the 5 and ∞ buttons to turn on orPlaying Discs Making a program list ¢ button to the previous six steps using the 4 buttonPress Program Shift Enter a disc number 1 toUsing repeat play Using random playMore programming options To view the playlist, press Program ShiftPlaying CDs only CD Mode Bookmarking a place in a discLooping a section of a disc Settings memorized are Memorizing disc settingsWhen a disc is stopped, all title/chapter, or track Displaying disc informationUsing the Timer Using the wake up timerActivating/deactivating the wake up timer Checking the timer settings Using the sleep timerAdvanced sound settings Advanced Sound SetupThere are three settings LFE attenuatorAdjusting channel volume levels Dual-mono settingUse the 2 and 3 buttons to select a channel to adjust When youre done, press EnterUsing the DVD Setup menu DVD Setup MenuVideo settings TV ScreenLanguage settings Audio Language Default Setting EnglishSubtitle Language Auto LanguageSetup Menu Mode General settingsDVD Language Subtitle DisplayChanging your password Parental LockChanging the parental lock level Default setting Off Input a new password, then press EnterDefault setting Blue Screen SaverSwitching the time format Setting the display brightnessAdditional Information Taking care of your systemGlossary Storing discsDiscs to avoid Language/Langue Language code listProblemRemedy TroubleshootingResetting the system Switching the demo mode on/offHold down the front panel 7 button and switch back on Screen sizes and disc formats When viewing a widescreen TV or monitorSpecifications 0 4 2 1 1 4 0
Top Page Image Contents