Classe Audio AMP5 owner manual Rack-mounting

Page 7

rack-mounting

Sigma series chassis are designed to accommodate rack-mount installation. Professional installation by an authorized Classé dealer is recommended.

To rack mount the AMP5, remove the two side-panel screws, invert and rotate the side panel to position the rack ear along the front of the AMP5 and re-install the side-panel screws. Repeat for the side panel on the opposite side. Remove the feet from the bottom of the AMP5.

Carefully install the AMP5 into the equipment rack using the appropriate screws for the type of rack. It is easiest if two people perform the installation to avoid the possibility of dropping the AMP5 or otherwise causing damage. Please allow for adequate ventilation, usually two rack spaces above the AMP5 will suffice.

Magnetically secured rack ear covers, provided in the accessory pack, may be used to cover the screws and finish off the appearance.

7

Image 7

Contents Five-Channel Amplifier Sigma SeriesClass Important Safety Instructions Contents Welcome to the Classé family Word about installationUnpacking and Placement Rack-mounting Page Special Design Features Flashing blue Standby button & LED status indicatorFront Panel On redCH2 CH5 Outputs Balanced XLR InputIR Input and Output Single-Ended RCA InputSpeaker Outputs Classé CAN-Bus Control PortsRS-232 Control Port DC Trigger Input and OutputAC Mains Input RJ-45 DB9 female adaptorRJ-45 USB PortConfigure your amplifier turn-on delay/amp number InstallationMake your preamp/processor connections Double-check all your connections Adjust the global system brightnessCAN-Bus Make your speaker connectionsCAN-Bus Terminator SSP-300 & 600 CAN-Bus Interface Box Classé CAN-Bus Equipped ProductsCategory 5 Network Cables CAN-Bus equipped components in your systemFor any system with SSP-300 or SSP-600 Any combination of models in any orderFollowing CAN-Bus features are shared by all models CAN-Bus shared featuresOperational status and serial number Configuration screen Following CAN-Bus features are model specificAmp info Event log Care and Maintenance Amplifier keeps shutting off TroubleshootingNo sound, and Standby LED is not lit No sound, and Standby LED is blinking redRating 15AH AC mains fuse is blownMains voltage 100-120VAC Fuse type Rating 3AH Mains voltage 200-240VAC Fuse typeSpecifications Dimensions Page +1 514 +1 514 636-1428 fax François Cusson Lachine, QuebecNorth America 514