Classe Audio AMP5 owner manual Classé CAN-Bus Equipped Products, Category 5 Network Cables

Page 17

hardware setup

1Classé CAN-Bus Equipped Products

Two or more Classé CAN-Bus equipped products are required, at least one of which must have a touchscreen display.

2Category 5 Network Cables

These are ordinary network cables, commonly used for broadband Internet connections. They should be typical “straight through” cables not the “crossed over” type, and the total required will be one less than the total number of

CAN-Bus equipped components in your system.

3CAN-Bus Terminator

A single CAN-Bus Terminator may be required. It is inserted into the CAN-Bus OUT connector of the last component in the CAN-Busdaisy chain. One is included in the box with your amplifier. They are also available free of charge from your nearest Classé Customer Support Centre. http://www.Classeaudio.com/support/service.htm

4SSP-300 & 600 CAN-Bus Interface Box

Systems that include an SSP-600 or SSP-300 will also require an

SSP-300/600CAN-Bus Interface Box. These are included with the products or available free of charge from your nearest Classé Customer Support Centre. http://www.Classeaudio.com/support/service.htm

17

Image 17
Contents Five-Channel Amplifier Sigma SeriesClass Important Safety Instructions Contents Welcome to the Classé family Word about installationUnpacking and Placement Rack-mounting Page Special Design Features Front Panel Standby button & LED status indicatorOn red Flashing blueCH2 CH5 Outputs Balanced XLR InputSpeaker Outputs Single-Ended RCA InputClassé CAN-Bus Control Ports IR Input and OutputRS-232 Control Port DC Trigger Input and OutputRJ-45 RJ-45 DB9 female adaptorUSB Port AC Mains InputMake your preamp/processor connections InstallationConfigure your amplifier turn-on delay/amp number CAN-Bus Adjust the global system brightnessMake your speaker connections Double-check all your connectionsCategory 5 Network Cables Classé CAN-Bus Equipped ProductsCAN-Bus equipped components in your system CAN-Bus Terminator SSP-300 & 600 CAN-Bus Interface BoxFor any system with SSP-300 or SSP-600 Any combination of models in any orderOperational status and serial number CAN-Bus shared featuresFollowing CAN-Bus features are shared by all models Configuration screen Following CAN-Bus features are model specificAmp info Event log Care and Maintenance No sound, and Standby LED is not lit TroubleshootingNo sound, and Standby LED is blinking red Amplifier keeps shutting offMains voltage 100-120VAC Fuse type AC mains fuse is blownRating 3AH Mains voltage 200-240VAC Fuse type Rating 15AHSpecifications Dimensions Page North America 514 François Cusson Lachine, Quebec+1 514 +1 514 636-1428 fax