Yamaha DSP-AX563 Optimizing the speaker setting for your listening room, Using Auto Setup, 24 En

Optimizing the speaker setting for your listening room

This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening environment.

Using AUTO SETUP
	2 Connect the supplied optimizer microphone
	to the OPTIMIZER MIC jack on the front
	panel.
Notes

OPTIMIZER MIC

• Be advised that it is normal for loud test tones to be output during the “AUTO SETUP” procedure.

• To achieve the best results, make sure the room is as quiet as possible while the “AUTO SETUP” procedure is in progress. If there is too much ambient noise, the results may not be

	VIDEO AUX	USB
VIDEO	L AUDIO	R

satisfactory.

y

AUDIO SELECT

You can run “AUTO SETUP” using the system menu that appears in the OSD or in the front panel display. This manual uses the OSD illustrations to explain the “AUTO SETUP” procedure.

1Make sure of the following check points.

Note

Before starting the automatic setup, check the following check points.

❏Speakers are connected appropriately.

❏Headphones are disconnected from this unit.

❏This unit and the video monitor are turned on.

❏This unit is selected as the video input source of the video monitor.

❏The connected subwoofer is turned on and the volume level is set to about half way (or slightly less).

❏The crossover frequency controls of the connected subwoofer is set to the maximum.

VOLUME		CROSSOVER
		HIGH CUT
MIN	MAX	MIN	MAX

Controls of a subwoofer (example)

❏FRONT A speakers are selected as the front speaker system (see page 33).

❏The room is sufficiently quiet.

Optimizer microphone

The following display appears in the OSD.

AUTO SETUP

SETUP;;;;;;;AUTO

.START

Automatic Processing of all item

[p]/[p]:Up/Down [p]/[[]:Select

3Place the optimizer microphone at your normal listening position on a flat level surface with the microphone heading upward.

Optimizer microphone

y

It is recommended that you use a tripod (etc.) to affix the optimizer microphone at the same height as your ears would be when you are seated in your listening position. You can use the attached screw of a tripod (etc.) to fix the optimizer microphone to the tripod (etc.).

24 En