Yamaha DSP-AX563 owner manual 71 En, After Auto Setup, 1OUT of Phase, 2OVER 24m 80ft, 3LEVEL Error

Troubleshooting

After AUTO SETUP

Warning message	Cause	Remedy	See
			page

W-1:OUT OF PHASE	Speaker polarity is not correct. This
	message may appear depending on the
	speakers even when the speakers are
	connected correctly.

Check the speaker connections for proper	12
polarity (+ or –).

W-2:OVER 24m (80ft)	The distance between the nearest speaker	Bring the speaker closer to the listening	—
	and the furthest speaker is out of adjustable	position.
	range.
W-3:LEVEL ERROR	The difference of volume level among	If “SWFR:TOO LOUD” or “SWFR:TOO	24, 53
	speakers is excessive. (No level correction	LOW” appears, adjust the output volume of
	is made.)	the subwoofer.
		Readjust the speaker installation so that all	—
		speakers are set in locations with similar
		conditions.
		Check the speaker connections.	11
		Use speakers of similar quality.	—

Notes

•If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.

•If a warning message “W-1”, “W-2”, or “W-3” appears, corrections are made, but they may not be optimal.

•If an error message “E-9” occurs repeatedly, please contact a qualified Yamaha service center.

INFORMATION ADDITIONAL

English

71 En