Notes On Installation
•Disconnect negative battery terminal before starting installation. Consult the vehi- cle’s owner’s manual for proper instruction.
•The unit is designed for a 12Volt DC negative ground operation system only. Before installing the unit, confirm that your vehicle is a 12Volt DC negative ground system.
•Be sure to connect the color coded leads according to the diagram. Incorrect con- nections may cause the unit to malfunction or damage the vehicle’s electrical sys- tem.
•Be sure to connect the negative
•The unit is only designed for use with 4 speakers. Do not combine output for use with 2 speakers. Do not ground negative speaker leads to the chassis ground.
•Make sure all the connections are completely correct before turning on your unit.
•When replacing the fuse(s), the replacement must be of the same amperage as shown on the fuse holder.
•Do not block vents or heater panels. Blocking them will cause heat to build up in- side and may result in fire.
•After completing the installation and before operating the unit, reconnect the bat- tery. Then press the (RES) button with a pointed object, such as a
Tools For Installation
•The 2 removal keys are supplied for removing the old unit and replacing with the
The following tools and supplies may also be needed for the installation:
TOOLS | SUPPLIES |
• Phillips | • Machine Screws |
• Wire Stripper | • Crimp Connectors |
• Wire Cutter | • 14 Gauge Wire for Power Connections |
• Hammer | • |
• Pencil |
|
• Electrical Tape |
|
• Electric Drill |
|
The above are NOT INCLUDED with the
3