Roadmaster VR500CS-BT manual Installation, DIN REAR-MOUNT Method B, Parts

Page 7

Installation

DIN REAR-MOUNT (Method B)

Installation using the screw holes on both sides of the unit.

1. Screw holes on the side of the unit.

2. Screws. Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket.

3. Vehicle’s Factory Mounting Bracket

4. Dashboard or Console

5. Hook (Remove this part)

Note: The mounting sleeve, outer trim ring, and the mounting strap are not used for this method of installation.

PARTS

2

Keys

2

Flat Washers

1

Hex Nut

1

Mounting Bolt

1

Mounting Sleeve (not shown)

1

Faceplate Case (not shown)

2

Lock Washers

1

1/8" Stereo Cable

1

Sheet Metal Screw

1

Remote Control

1

Metal Support Strap

1

External Microphone

6

Image 7
Contents Page Contents Care of Discs PrecautionsTools Supplies Tools For InstallationRemove the Old Unit from the Dashboard Before You InstallDIN FRONT-MOUNT Method a InstalltionDIN REAR-MOUNT Method B InstallationParts Built-In Microphone MicrophonesMicrophone Jack Speaker Wiring Notes Wiring ConnectionsBNDID3 Location Of The ControlsOperating the Remote Control Remote ControlReplacing the Battery Basic Operation Bluetooth Connection Speed Dialing a Phone Number Disconnecting the PhoneRecently Received Calls Speed DialRadio Operation Mask DPI Mask ALL CD OperationRetune S/L SHORT/LONG Resume All Tracks Multi-Session CD ReadingSelecting Tracks Play/Pause CDSD/MMC Card USB/SD/MMC Card OperationSearch Modes RCA Out, SUB Out & ID3 Tag MaintenanceID3 TAG & Scrolling Modes FM Tuner SpecificationsGeneral CD PlayerLimited Warranty