Orion Car Audio XTR1002 owner manual Full Flush Mounting, Figura

FULL FLUSH MOUNTING

Step 1: Determine where the tweeter will be mounted. Make sure there is a flat area large enough for the tweeter and no obstructions behind the area.

Step 2: Using supplied template mark with a pen the hole needed for the tweeter.

Step 3: Be sure the hole is large enough for the tweeter housing.

Step 4: Cut the hole for the tweeter. When using factory locations, this step can be skipped. A hole can be cut either with a pair of metal tin snips or a 2" hole saw for soft materials or 2-1/8" hole saw for hard materials.

WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill.

Step 5: Install tweeter in flush mount housing.

Step 6: Connect the speaker wires observing the correct polarity.

Step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat with the front of the surface.

Step 8: Use the supplied x bracket to secure the housing to the surface.

Flush Mount	Tweeter	X Bracket
Tweeter Assembly	Cup
	Screw

Figure 2	Flush Mount	Tweeter		Wiring
Figura 2
				Harness
Abbildung 2	Trim Ring	Wire	Panel

© 2008 directed electronics—all rights reserved 5