12-2154.fm Page 13 Wednesday, July 14, 1999 3:34 PM
wrench to attach the short end of the supplied mounting bolt to the back of the
stereo.
(illus)
7.Reconnect the wire harness and the antenna.
8.Slide the stereo into the sleeve until it locks into place.
9.If you are securing the stereo in an existing mounting hole in the dash, push the supplied rubber mounting grommet onto the mounting bolt.
(illus - show mounting grommet)
Then push the mounting bolt (cov- ered by the mounting grommet) through that mounting hole and make sure it is secure.
Otherwise, you can use one of the supplied bolts (with attached washer) to attach one end of the supplied metal strap to the mount- ing hole on the back of the stereo.
If necessary, bend the metal strap to fit your vehicle’s mounting area. Then use either the supplied sheet metal screws or the other bolt (with attached washer) to attach the other end of the strap to a solid metal part of the vehicle under the dashboard. This strap also helps ensure proper electrical grounding of the stereo.
(illus - show bolt (with attached washers))
10.Reconnect the cable to the vehi- cle battery’s negative
Note: You might need to reset the stereo’s clock after you reconnect the cable to the vehicle battery.
13