CD PLAYER OPERATION
Cautions:
• Play only CDs that have this mark on them:
•The CD player has a wide dynamic range. As a result, if you turn your stereo’s volume up too high during soft (low volume) sec- tions of a program, your speakers might be damaged when a sud- den loud passage occurs.
•If the CD player is jolted during play, the rotation speed might sud- denly change or the CD player might make an unusual noise. This is not a malfunction.
PLAYING A CD
1.Press ON/OFF to turn on the ste- reo.
2.Insert a CD (label side up) in the slot. The stereo automatically switches to CD play mode if the radio is playing and displays cd
In. Then the display shows
,cd, and TR01, and the CD starts to play from Track 1.
(illus)
If a CD is already in the CD player
( appears on the display), simply press CD to play the CD. The stereo displays cd, TR, and the number of the track you last
22
played, and the CD starts to play from the point where you last stopped it.
(illus)
After the stereo plays the entire CD, it automatically repeats all tracks, starting with Track 1.
3.Press + or – to increase or decrease the volume as desired.
Note: See “Adjusting the Sound” on Page 17 for information about changing the stereo’s other set- tings.
4.To pause playback, press CD. TR and the track number flash. To resume play, press CD again.
Note: If you pause a CD for more than 5 minutes, the stereo turns off.
5.To remove a CD from the CD player, press 
. EJ cd appears.
(illus)