Sanyo FXD-780RDS operating instructions Contents

Page 2

CONTENTS
COMPACT DISC CARE	2
DIGITAL DISPLAY	3
DETACHABLE FRONT PANEL	4
GENERAL OPERATION	5
RADIO OPERATION	9
RDS OPERATION	11
CD OPERATION	14
CD CHANGER OPERATION	16
ERROR SIGNS	18
HINTS FOR PROPER AND SAFE OPERATION	19
TROUBLESHOOTING	20
ACCESSORIES AND HARDWARE	21
UNIT REMOVAL	22
ELECTRICAL CONNECTIONS	23
LINE OUT CONNECTIONS	24
CAUTION

•This unit is designed to operate on 12 volts DC, NEGATIVE ground electrical systems only.

•When fuse replacement is necessary, use only a 10 amp fuse. Do not replace with a higher rated fuse. If the fuse blows often, carefully check all electrical connections for any short circuits and have your car’s voltage regulator checked also.

•Do not install the unit where it will be exposed to direct sunlight or hot air discharged from the car heater.

•Do not expose the unit to water or moisture.

•To avoid damaging the unit, never insert anything other than a compact disc into the disc slot.

•This unit should not be adjusted or repaired by anyone except qualified service personnel. If servicing is required, return the unit to an authorized SANYO mobile audio dealer.

•Use the Controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

•Changes or modifications not expressly approved by SANYO may void the uses’s authority to operate this equipment.

GB–1

Image 2

Contents FXD-780RDSwith CD Changer Control Contents Compact Disc Care Recommended CD-R MediaBAS-X Digital DisplayREG PTY Returning to the Initial Settings HOW to Attach the Front PanelHOW to Detach the Front Panel Security IndicatorSetting the Clock Turning the Power onVolume Level Control General OperationLoudness Effect Switching the DisplayAdjusting the Sound LOCAL/DISTANTLO/DX SelectionEnhancing the Bass Sound BAS-X TEL Mute Function Adjusting the Sound StageIGNITION-OFF Clock Recall To Memory the Sound StageStoring Preset Stations Selecting Radio ModeRadio Tuning Radio OperationScan Operation ATP Auto Travel Preset OperationPreset Scan Operation RDS Operation Selecting AF ModeSelecting TA Mode Changing the Displayed ItemsReceiving Traffic Announcements Automatic RE-TUNINGPresetting the Volume of Traffic Announcements Selecting REG on or REG OFFLocating a Station with PTY Programme types DisplayLoading and Ejecting the CD Switching to CD ModeCD Operation Skipping TracksRepeat Mode Scan Mode Playing the BeginningPlacing the CD in Pause Mode Shuffle ModeSelecting a Disc Putting the CD in Pause ModeCD Changer Operation Repeat Mode Scan Mode Playing the Beginning of Tracks or DiscsMeck ERR Error SignsCD Error Message Cause RemedyHints for Proper and Safe Operation Troubleshooting Symptom Cause SolutionInstallation Accessories and HardwareInstallation Before InstallationFire Wall Installation ProceduresUnit Removal Dash BoardWiring Electrical ConnectionsCD Changer DIN Socket Line OUT ConnectionsReplacing the Fuse RCA Line- out Jacks For Rear Speakers