Sanyo FXD-780RDS operating instructions Electrical Connections, Wiring

Page 24

ELECTRICAL CONNECTIONS

WIRING

ANTENNA SOCKET

ANTENNA PLUG

4-speaker System

(White)

(White/Black)Front Left Speaker

(Gray)

(Gray/Black)Front Right Speaker

(Green)

(Green/Black)Rear Left Speaker

(Violet)

Rear Right

(Violet/Black)

Speaker

 

In the case of a 2-speaker system, tape the ends of unconnected terminals to prevent short circuit

2-speaker System

(White)

(White/Black)Left Speaker

(Gray)

(Gray/Black)Right Speaker

(Green)

(Green/Black)

Do Not

Connect

 

(Violet

Do Not

(Violet/Black)

Connect

 

+12V Constant Power Supply (Yellow)

+12V Accessory/Switched (Red)

Ground Wire (Black)

Power Antenna/Amplifier Turn On (Blue)

Tel mute (Brown)

CAUTION

DO NOT connect any speaker wires to the metal body or chassis of the vehicle.

DO NOT connect the speaker common (–) wires to each other.

Connect each speaker wire directly to each speaker terminal.

All speaker common (–) wires must remain floating.

1Antenna socket

Insert the plug from the antenna installed in your vehicle into this socket. (If your vehicle has a dual antenna system, a dual antenna to single antenna cable adaptor may be required.)

2+ 12V Constant Power Supply (Yellow)

Connect this wire to the +12V power terminal which receives power continuously.

3+12V Accessory/Switched (Red)

Connect this wire to the terminal which receives power while the ignition switch is ON or in the ACCES- SORY position.

4Ground wire (Black)

Connect this wire to the vehicle chassis.

5Power Antenna/Amplifier Turn On (Blue)

Connect this wire to the control terminal of a Power Antenna or an external amplifier.

When not using a Power Antenna or an external amplifier, this wire is not connected.

6Tel mute (Brown)

Connect to the terminal that is grounded when either the telephone rings or during conversation.

GB–23

Image 24
Contents FXD-780RDSwith CD Changer Control Contents Compact Disc Care Recommended CD-R MediaDigital Display REG PTYBAS-X HOW to Attach the Front Panel HOW to Detach the Front PanelReturning to the Initial Settings Security IndicatorTurning the Power on Volume Level ControlSetting the Clock General OperationSwitching the Display Adjusting the SoundLoudness Effect LOCAL/DISTANTLO/DX SelectionEnhancing the Bass Sound BAS-X Adjusting the Sound Stage IGNITION-OFF Clock RecallTEL Mute Function To Memory the Sound StageSelecting Radio Mode Radio TuningStoring Preset Stations Radio OperationATP Auto Travel Preset Operation Preset Scan OperationScan Operation Selecting AF Mode Selecting TA ModeRDS Operation Changing the Displayed ItemsAutomatic RE-TUNING Presetting the Volume of Traffic AnnouncementsReceiving Traffic Announcements Selecting REG on or REG OFFLocating a Station with PTY Programme types DisplaySwitching to CD Mode CD OperationLoading and Ejecting the CD Skipping TracksScan Mode Playing the Beginning Placing the CD in Pause ModeRepeat Mode Shuffle ModePutting the CD in Pause Mode CD Changer OperationSelecting a Disc Repeat Mode Scan Mode Playing the Beginning of Tracks or DiscsError Signs CD ErrorMeck ERR Message Cause RemedyHints for Proper and Safe Operation Troubleshooting Symptom Cause SolutionAccessories and Hardware InstallationInstallation Before InstallationInstallation Procedures Unit RemovalFire Wall Dash BoardWiring Electrical ConnectionsLine OUT Connections Replacing the FuseCD Changer DIN Socket RCA Line- out Jacks For Rear Speakers