Sanyo FXD-780RDS operating instructions Hints for Proper and Safe Operation

Page 20

HINTS FOR PROPER AND SAFE OPERATION

Condensation

Moisture can condense on the optical lens of the CD player during humid or rainy days, or after the car heater is turned on. If this occurs the disc player may not function properly. To remedy the situation, remove the disc from the unit and wait approximately one hour. This should allow the moisture to evapo- rate and restore normal operation.

Temperature Consideration

The unit may not operate correctly in extremely hot or cold temperatures. Avoid exposing the unit to extremely high or low temperatures.

Interruptions in the sound (skipping)

When the car is driven on very rough surfaces, the sound from the CD player may skip and be inter- rupted. This will not cause any damage to the disc or the player. If this occurs, wait for the road surface to improve before using the CD player.

Safety

For safer driving, keep the volume at a moderate level to enable you to hear outside sounds (such as emergency vehicle sirens).

Cleaning the unit

Clean the unit with a soft, dry cloth. Stains should be removed by wiping the surfaces with a soft cloth immersed in lukewarm water and wrung dry. Never use strong chemicals or solvents. These will damage the finish of the unit.

Disc care

When not using the disc player for extended periods, remove the compact disc and return it to the plastic storage case. Do not leave a disc partially ejected from the player. If an ejected disc remains in the loading slot for approximately 10 seconds, the player will reload the disc to prevent damage.

Servicing

Should a problem develop, do not open the unit or try to repair it yourself. If servicing is required, bring the unit to a Sanyo Authorized Service Center.

GB–19

Image 20
Contents FXD-780RDSwith CD Changer Control Contents Compact Disc Care Recommended CD-R MediaBAS-X Digital DisplayREG PTY HOW to Attach the Front Panel HOW to Detach the Front PanelReturning to the Initial Settings Security IndicatorTurning the Power on Volume Level ControlSetting the Clock General OperationSwitching the Display Adjusting the SoundLoudness Effect LOCAL/DISTANTLO/DX SelectionEnhancing the Bass Sound BAS-X Adjusting the Sound Stage IGNITION-OFF Clock RecallTEL Mute Function To Memory the Sound StageSelecting Radio Mode Radio TuningStoring Preset Stations Radio OperationScan Operation ATP Auto Travel Preset OperationPreset Scan Operation Selecting AF Mode Selecting TA ModeRDS Operation Changing the Displayed ItemsAutomatic RE-TUNING Presetting the Volume of Traffic AnnouncementsReceiving Traffic Announcements Selecting REG on or REG OFFLocating a Station with PTY Programme types DisplaySwitching to CD Mode CD OperationLoading and Ejecting the CD Skipping TracksScan Mode Playing the Beginning Placing the CD in Pause ModeRepeat Mode Shuffle ModeSelecting a Disc Putting the CD in Pause ModeCD Changer Operation Repeat Mode Scan Mode Playing the Beginning of Tracks or DiscsError Signs CD ErrorMeck ERR Message Cause RemedyHints for Proper and Safe Operation Troubleshooting Symptom Cause SolutionAccessories and Hardware InstallationInstallation Before InstallationInstallation Procedures Unit RemovalFire Wall Dash BoardWiring Electrical ConnectionsLine OUT Connections Replacing the FuseCD Changer DIN Socket RCA Line- out Jacks For Rear Speakers