Sanyo FXD-780RDS Line OUT Connections, Replacing the Fuse, CD Changer DIN Socket

Page 25

Notes

•When using a two-speaker installation, the Green, Green/Black, Violet, Vio- let/Black wires, which are used for a four-speaker installation, are not used. The ends of these wires must be covered with electrical tape to prevent them from shorting to the unit or the vehicle chassis.

•When using a two-speaker installation, set the FADER control to the center position.

REPLACING THE FUSE

When fuse replacement is necessary remove the blown fuse by using pliers. Then install the new 10 amp. fuse.

LINE OUT CONNECTIONS

•The unit has a built-in CD changer controller and line out terminals. You can use a compatible Sanyo CD changer and a separate rear channel amplifier to upgrade your system.

RCA Line-out Jacks

White (Left)

Red (Right)

External Amplifier

CD Changer DIN Socket

Rear Speaker

CD Changer

CD Changer DIN Socket

•Connect the 8-pin DIN cable, which is supplied with the compatible Sanyo CD changer, to the DIN socket on the back of the unit.

RCA Line- out Jacks (For Rear Speakers)

•Connect a patch cable (not supplied) from the White (left rear channel) and Red (right rear channel) RCA line output jacks to the line input terminals of the external amplifier.

GB–24

Image 25

Contents FXD-780RDSwith CD Changer Control Contents Recommended CD-R Media Compact Disc CareREG PTY Digital DisplayBAS-X HOW to Detach the Front Panel HOW to Attach the Front PanelReturning to the Initial Settings Security IndicatorVolume Level Control Turning the Power onSetting the Clock General OperationAdjusting the Sound Switching the DisplayLoudness Effect LOCAL/DISTANTLO/DX SelectionEnhancing the Bass Sound BAS-X IGNITION-OFF Clock Recall Adjusting the Sound StageTEL Mute Function To Memory the Sound StageRadio Tuning Selecting Radio ModeStoring Preset Stations Radio OperationPreset Scan Operation ATP Auto Travel Preset OperationScan Operation Selecting TA Mode Selecting AF ModeRDS Operation Changing the Displayed ItemsPresetting the Volume of Traffic Announcements Automatic RE-TUNINGReceiving Traffic Announcements Selecting REG on or REG OFFProgramme types Display Locating a Station with PTYCD Operation Switching to CD ModeLoading and Ejecting the CD Skipping TracksPlacing the CD in Pause Mode Scan Mode Playing the BeginningRepeat Mode Shuffle ModeCD Changer Operation Putting the CD in Pause ModeSelecting a Disc Scan Mode Playing the Beginning of Tracks or Discs Repeat ModeCD Error Error SignsMeck ERR Message Cause RemedyHints for Proper and Safe Operation Symptom Cause Solution TroubleshootingInstallation Accessories and HardwareInstallation Before InstallationUnit Removal Installation ProceduresFire Wall Dash BoardElectrical Connections WiringReplacing the Fuse Line OUT ConnectionsCD Changer DIN Socket RCA Line- out Jacks For Rear Speakers