Sharp PN-K321 11 E, Installing the stand supplied NHeight/angle adjustment, Adjusting the height

Page 11

Installing the stand (supplied)

nHeight/angle adjustment

•Adjusting the height

Adjust to a height that is easy to view.

Approx.

5-29/32inch (15cm)

TIPS

•The height cannot be adjusted in a vertical installation.

•Adjusting the angle

Adjust to an angle that is easy to view.

Approx.25°

Approx.5°

Approx.45°

Caution

•When moving the monitor, be sure to grasp only the frame. Grasping and applying pressure to the LCD panel may damage it.

•Take care not to pinch your fingers.

•If you are installing the monitor in landscape orientation, take caution when adjusting the angle at a raised height, so that it does not topple.

11 E

Image 11

Contents PN-K321 Page Important Information Refer Servicing to Qualified Service PersonnelDear Sharp Customer Safety Precautions Tips and Safety Instructions Front For the monitor in landscape orientationFor the monitor in portrait orientation BackSupplied Components ContentsNRear view Attachment plate for stand Brightness adjustment buttonPart Names NFront viewNAttaching the stand Installing the stand supplied11 E Installing the stand supplied NHeight/angle adjustmentAdjusting the height Adjusting the angleConnecting Peripheral Equipment 13 E Connecting the Power CordNStoring the cables Binding CablesNFastening the cables 15 E Turning Power On/OffPower lamp status Status of the monitor Basic Operation Dot by Dot Basic Operation NSwitching the screen size17 E Wide NormalContrast Menu ItemsNExample of operation NMenu screen displayNPICTURE 19 EMenu Items NPbyP Menu Items NSETUPNMONITOR Menu Items NOTHERS 21 EHDMI1 HDMI2 Menu Items NDual screen displayNHDMI Dual PbyP23 E Volm NCommand formatControlling the Monitor with a PC RS-232C 25 E When a command has been executed correctlyWhen a command has not been executed If execution of the command is taking some timeControlling the Monitor with a PC RS-232C Power control/Input mode selectionHow to read the command table Controlling the Monitor with a PC RS-232C Picture menu 27 EOthers menu Controlling the Monitor with a PC RS-232C Setup menuMonitor menu PbyP menuOthers 29 ETroubleshooting Vesa DDC2B SpecificationsNProduct Specifications 31 EUnit inch mm Specifications NDimensional DrawingsHDMI1 Hdmi Dual *1 Specifications NCompatible signal timing PCScreen resolution Vsync DisplayPort 33 ENDDC plug and play Specifications NCompatible signal timing AVNPower management 35 E NDisplayPort input terminal pinsSpecifications NPC/AV Hdmi input terminal pins Hdmitm ConnectorBack of monitor NToppling preventionNRemoving the attachment plate Top of monitorPN-K321 Ma EN13D3