Sharp PN-K321 operation manual Binding Cables, NFastening the cables, NStoring the cables

Page 14

Binding Cables

nFastening the cables

The cables connected to the terminals on the rear of the monitor can be fastened with the cable clamp.

Attach the cable clamps to the attachment parts on the back of the monitor and the stand, and bind the cables.

Cable

Cable clamp

attachment

Cable clamp

Cable clamp (small)

Cable clamp (large)

Cable clamp	Cable	Cable clamp	Cable
			Cable

attachment		attachment

nStoring the cables

The cables connected to the rear of the monitor can be bound using the cable clamp on the stand.

• Landscape

• Portrait

Cable clamp (large)

Cable clamp	Cable
Cable clamp
attachment
Caution

• Do not forcibly bend or apply force to the cables. Risk of wire breakage or other damage.

E14

Image 14

Contents PN-K321 Page Refer Servicing to Qualified Service Personnel Important InformationDear Sharp Customer Safety Precautions Tips and Safety Instructions Back For the monitor in landscape orientationFor the monitor in portrait orientation FrontContents Supplied ComponentsNFront view Attachment plate for stand Brightness adjustment buttonPart Names NRear viewInstalling the stand supplied NAttaching the standAdjusting the angle Installing the stand supplied NHeight/angle adjustmentAdjusting the height 11 EConnecting Peripheral Equipment Connecting the Power Cord 13 ENStoring the cables Binding CablesNFastening the cables 15 E Turning Power On/OffPower lamp status Status of the monitor Basic Operation Wide Normal Basic Operation NSwitching the screen size17 E Dot by DotNMenu screen display Menu ItemsNExample of operation ContrastNPICTURE 19 EMenu Items NPbyP Menu Items NSETUPNMONITOR 21 E Menu Items NOTHERSPbyP Menu Items NDual screen displayNHDMI Dual HDMI1 HDMI223 E Volm NCommand formatControlling the Monitor with a PC RS-232C If execution of the command is taking some time When a command has been executed correctlyWhen a command has not been executed 25 EControlling the Monitor with a PC RS-232C Power control/Input mode selectionHow to read the command table 27 E Controlling the Monitor with a PC RS-232C Picture menuPbyP menu Controlling the Monitor with a PC RS-232C Setup menuMonitor menu Others menu29 E OthersTroubleshooting 31 E SpecificationsNProduct Specifications Vesa DDC2BSpecifications NDimensional Drawings Unit inch mm33 E Specifications NCompatible signal timing PCScreen resolution Vsync DisplayPort HDMI1 Hdmi Dual *1NDDC plug and play Specifications NCompatible signal timing AVNPower management Hdmitm Connector NDisplayPort input terminal pinsSpecifications NPC/AV Hdmi input terminal pins 35 ETop of monitor NToppling preventionNRemoving the attachment plate Back of monitorPN-K321 Ma EN13D3