Quick guide
Initial auto installation
When the TV is powered on for the first time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.
Confirm the following before turning on the power
EIs the antenna cable connected? E Is the AC cord plugged in?
1 Press a on the TV.
• The initial auto installation wizard appears.
2Setting the OSD language.
English
Português
Press a/bto select the desired language, and then press ;.
3Selecting the location of the TV.
HOME
STORE
Press a/bto select where you will use this TV, and then press ;.
•HOME: “STANDARD” will be the default value for the “AV MODE” setting.
•STORE: “DYNAMIC (Fixed)” will be the default value for the “AV MODE” setting. If the “AV MODE” is changed, the TV will automatically switch back to “DYNAMIC (Fixed)” when there is no signal input from the TV or remote control unit for 30 minutes.
4Setting the country.
Austria
Finland
Press a/bto select your country or area, and then press ;.
•This setting screen only appears during the first installation.
5Starting channel search.
Start
Skip
Press a/bto select “Start” or “Skip”, and then press ;.
•If you want to search for more broadcasts, execute “Additional Search” from the “Programme Setup” menu (Page 21).
6The TV searches for, sorts and stores all the receivable TV stations according to their settings and the connected antenna.
•To abort the initial auto installation in progress, press
RETURN.
NOTE
•If you turn off the power on the TV after performing step 5 or if you select “Skip” on step 5, the initial auto installation wizard will not appear. The auto installation function allows you to execute the installation again from the “Setup” menu (Page 20).
•The initial auto installation wizard will go off if you leave the TV unattended for 10 minutes before searching for channels in step 6.
•After initial auto installation is completed, the default PIN is automatically set to “1234”. To change the PIN setting, refer to Password/Parental lock settings (Page 22). To clear the PIN setting (PIN input will no longer be needed), refer to CLEARING THE PIN (Page 24).
•When “Italy” is selected in the country setting, the default PIN is automatically set to “1234” and the default age restriction value is set to 18.
Checking signal strength
If you install an antenna for the first time or relocate it, you should adjust the alignment of the antenna to receive a good reception while checking the antenna setup screen.
1Press @ and the “MENU” screen displays.
2Press c/dto select “Setup”.
3Press a/bto select “Antenna Setup”, and then press ;.
4Press a/bto select “Signal Strength”.
NOTE
•The values of “Signal Strength” indicates when to check the appropriate alignment of the antenna.
9