Sharp LC-32DH57E Connecting a PC, Auto Sync, Fine Sync, Adjusting the PC image automatically

Connecting a PC

Adjusting the PC image automatically

This function enables the screen to be automatically adjusted to its best possible condition when the analogue terminals of the TV and PC are connected with a commercially available DVI/RGB conversion cable, etc.

Setup

Auto Sync.

NOTE

•“Auto Sync.” may fail if the PC image has low resolution, has unclear (black) edges, or is moved while executing “Auto Sync.”.

•Be sure to connect the PC to the TV and switch it on before starting “Auto Sync.”.

•“Auto Sync.” can be executed only when inputting analogue signals through the EXT 4 terminal.

Adjusting the PC image manually

Ordinarily you can easily adjust the picture as necessary to change image position using “Auto Sync.”. In some cases, however, manual adjustment is needed to optimise the image.

Setup

Fine Sync.

1Press a/bto select the specific adjustment item.

2Press c/dto adjust the item to the desired position.

H-Pos. [ 0] -30 b30

V-Pos. [-5] -20 b20

Clock	[ 0]	-15	b15
Phase	[ 0]	-15	b15

	Item
H-Pos.	Centres the image by moving it to the left or
	right.
V-Pos.	Centres the image by moving it up or down.
Clock	Adjusts when the image flickers with vertical
	stripes.
Phase	Adjusts when characters have low contrast or
	when the image flickers.

NOTE

•For resetting all adjustment items to the factory preset values, press a/bto select “Reset”, and then press ;.

•“Clock” and “Phase” in the “Fine Sync.” menu can be adjusted only when inputting analogue signals through the EXT 4 terminal.

26