Sharp TV Wall Mount Instructions for AN-37AG2 and Aquos 70 Models

Appendix

Mounting the TV on the wall

Removing the stand

For wall mounting with the optional bracket, remove the stand.

Before detaching/attaching the stand

•Before detaching (or attaching) the stand, unplug the AC cord from the AC outlet.

•Remove all terminal covers and connected cables.

•Lay the TV down on cushioning (such as a blanket) over a table.

•Make sure two or more people perform the operation.

CAUTION

• Do not

from the TV unless using an optional it.

1

Unfasten the in place.

NOTE

Screw driver (not supplied)

the stand

2

Stand post

1

1 Detach the stand from the TV. (Hold the stand so it will not drop from the edge of the base area.)

2 Remove the stand post from the stand base and attach it to the TV.

• To attach the stand, perform the above steps in reverse order.

Handling and precautions with the wall-mounted TV

•You can mount the TV on the wall using the optional AN-37AG2 bracket and AN-37P30 attachment.

•For details, refer to the instructions supplied with the optional bracket.

CAUTION

•This TV should be mounted on the wall only with the AN-37AG2 (SHARP) / AN-37P30 (SHARP) wall mount bracket. The use of other wall mount brackets may result in an unstable installation and may cause serious injuries.

•Installing the Liquid Crystal Television requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury.

Using an optional bracket to mount the TV

•You can ask a qualifi ed service personnel about using an optional AN-37AG2 bracket and AN-37P30 attachment to mount the TV to the wall.

•Carefully read the instructions that come with the bracket before beginning work.

Hanging on the wall About setting the TV angle

AN-37AG2/AN-37P30 wall mount bracket. (See the bracket instructions for details.)

Vertical mounting Angular mounting AN-37AG2 + AN-37P30

NOTE

•Detach the cable clamps on the rear of the TV when using the optional mount bracket.

•To use this TV mounted on a wall, fi rst remove the cover at the 4 locations on the rear of the TV, and then use the screws

68supplied with the wall mount bracket to secure the bracket to the rear of the TV.

LC-40LE700X.indb 68

6/26/09 4:26:27 PM