Testing, Remote Input Level Control | Jensen 5500 specification

POWER 5500 5-Channel Amplifier

Testing

Before finishing the installation, perform the following tests to make sure the wiring is correct and everything is operating properly.

Reconnect Battery

When wiring is complete, reconnect the battery negative terminal.

Test Power Wiring

Turn on the receiver, but do not turn up the volume. The amplifier power light should come on. If not, check the REM and +12V (B+) wires. Turn up the receiver volume slightly. All speakers should operate. If not, check wiring connections at amplifier and speakers.

Test Speaker Connections

These tests make sure the speakers are connected properly. If speakers don’t play at all, one (or both) speaker wires may be disconnected.

Remote Input Level Control

The Power 5500 comes equipped with a Remote Input Level Control. The Remote Input Level Control allows the input level to be adjusted from an alternate location. It can be mounted under-dash or in-dash. When the amplifier is used to drive subwoofers and the low pass crossover is activated, the Remote Input Level Control can be used as a « remote bass level control”. This enables you to control the bass level independent from the rest of the system. This is convenient for system tuning and/or when playing many different types of music.

The Remote Input Level Control uses a 6-pin modular cable for connectivity. Simply plug the 6-pin modular cable into the amplifier and then into the Remote Input Level Control to activate the circuit.

Power

Min

Max

REMOTE

CH5/1	CH4	CH2		CH3/4		MODE		CH1/2		REMOTE
CH5/1	CH4	CH2		CH3/4		MODE		CH1/2
		LEVEL		HPF		LEVEL		HPF
INPUT		MIN	MAX	FULL HPF 16Hz	160Hz	4CH 5CH MIN	MAX	FULL HPF 16Hz	160Hz
INPUT
		MIN	MAX	16Hz	60Hz	0dB	12dB	30Hz	160Hz	POWER
		LEVEL		SUB SONIC		BASS EQ		LPF		PROTECT
CH5/2	CH3	CH1				CH5