Jensen 5500 operation manual Input Wiring, 4CH 5CH MIN

POWER 5500 5-Channel Amplifier

Input Wiring

Most trunk/hatchback installations will require a 15-20 foot RCA cable, while pickup trucks and under-seat mounting will require a 6-12 foot RCA cable. Connect an RCA cable from your receiver to the RCA input on your amplifier.

CH5/1	CH4	CH2		CH3/4		MODE		CH1/2		REMOTE
		LEVEL		HPF		LEVEL		HPF
INPUT		MIN	MAX	FULL HPF 16Hz	160Hz	4CH 5CH MIN	MAX	FULL HPF 16Hz	160Hz
		MIN	MAX	16Hz	60Hz	0dB	12dB	30Hz	160Hz	POWER
		LEVEL		SUB SONIC		BASS EQ		LPF		PROTECT
CH5/2	CH3	CH1				CH5

NOTE: The use of good quality RCA cables is just as important as power and speaker wire. Choose a high quality low capacitance cable for the best results.

CH5/1	CH4	CH2		CH3/4		MODE		CH1/2		REMOTE
		LEVEL		HPF		LEVEL		HPF
INPUT		MIN	MAX	FULL HPF 16Hz	160Hz	4CH 5CH MIN	MAX	FULL HPF 16Hz	160Hz
		MIN	MAX	16Hz	60Hz	0dB	12dB	30Hz	160Hz	POWER
		LEVEL		SUB SONIC		BASS EQ		LPF		PROTECT
CH5/2	CH3	CH1				CH5

(R) (L) (R) (L) (L) (R) (SUB)

5 Channel

MODE

(R) (L) (L) (R)

Bridged Mode

MODE

4CH 5CH 4CH 5CH

(R) (L) (R) (L)

(L) (R)

TO HEAD UNIT

(SUB)	(L)	(R)
		TOHEADUNIT

NOTE: Power amplifiers can drive speakers with a nominal impedance range of 2~4 ohms. For maximum power, configure your speakers for a nominal 2-ohm load. Bridged amplifier channels can only drive a 4-ohm minimum impedance load.

6