Kramer Electronics VA-8xl user manual Atmel Flip Window Operation Completed

Page 26

Figure 19: Atmel – Flip Window (Operation Completed)

8.Close the “Atmel – Flip” window.

9.Turn the POWER switch on the VA-8xl OFF.

10.Disconnect the RS-232 9-pin D-sub rear panel port on the VA-8xlunit from the null modem adapter.

11.Set DIP 7 OFF.

12.Set DIP 8 OFF.

13.Turn the POWER switch on the VA-8xlON.

Upon initialization, the new VA-8xlsoftware version shows in the RIGHT LED display.

VA-8xl - Upgrading the Flash Memory

23

Image 26

Contents VA-8xl Page Figures Introduction Getting Started Achieving the Best PerformanceOverview This section defines the VA-8xlPower Switch VA-8xl 8-Channel Balanced Stereo Audio Amplifier Rear Panel Connecting the VA-8xl If required, connect a PC via RS-232, seeVA-8xl Connecting the VA-8xl Adjusting the Gain/Attenuation of the Channels Operating the VA-8xlStoring and Recalling Setups To store a setting, via the front panel buttonsVA-8xl Operating the VA-8xl Preparing the RS-232 Port on a Single Unit Controlling the VA-8xlControlling a Single VA-8xl Unit To PC Illustrates how to configure up to 15 VA-8xlunits Connecting a Control Interface on a Set of Units Preparing the RS-232 Connectors Connecting the RS-485 Control Interface An RS-485 Control Interface Setup Downloading from the Internet Connecting the PC to the RS-232 PortUpgrading the Flash Memory Upgrading Firmware Splash ScreenOpen Configuration File window appears Atmel Flip Window RS-232 Communication If an error message Not Finished shows, click Run again Atmel Flip Window Operation Completed Technical Specifications Default Communication Parameters RS-232 ProtocolKramer Protocol 1st ByteHex Codes for Attenuation Gain Control Hex Codes for Amplification Gain Control Channel Number CodesVA-8xl Kramer Protocol 2900