Kramer Electronics VA-8xl user manual If an error message Not Finished shows, click Run again

Page 25

Figure 18: Atmel – Flip Window (Connected)

7.Click Run.

After each stage in the operation is completed, the check-box for that stage becomes colored green (see also the blue progress indicator on the status bar).

When the operation is completed, all 4 check-boxes will be colored green

and the status bar message: Memory Verify Pass appears:

If an error message: “Not Finished” shows, click Run again.

22	VA-8xl - Upgrading the Flash Memory

Image 25

Contents VA-8xl Page Figures Introduction Achieving the Best Performance Getting StartedThis section defines the VA-8xl OverviewPower Switch VA-8xl 8-Channel Balanced Stereo Audio Amplifier Rear Panel If required, connect a PC via RS-232, see Connecting the VA-8xlVA-8xl Connecting the VA-8xl Operating the VA-8xl Adjusting the Gain/Attenuation of the ChannelsTo store a setting, via the front panel buttons Storing and Recalling SetupsVA-8xl Operating the VA-8xl Controlling a Single VA-8xl Unit Controlling the VA-8xlPreparing the RS-232 Port on a Single Unit To PC Illustrates how to configure up to 15 VA-8xlunits Connecting a Control Interface on a Set of Units Preparing the RS-232 Connectors Connecting the RS-485 Control Interface An RS-485 Control Interface Setup Upgrading the Flash Memory Connecting the PC to the RS-232 PortDownloading from the Internet Splash Screen Upgrading FirmwareOpen Configuration File window appears Atmel Flip Window RS-232 Communication If an error message Not Finished shows, click Run again Atmel Flip Window Operation Completed Technical Specifications RS-232 Protocol Default Communication Parameters1st Byte Kramer ProtocolHex Codes for Attenuation Gain Control Channel Number Codes Hex Codes for Amplification Gain ControlVA-8xl Kramer Protocol 2900