3Detailed instructions
3.2.2Station search/station memory
The TechniSat WERRA 1 offers four different possibilities to search for the radio station: manual station search, automatic station search, AST function and search for the type of programme.
The stations which have been found can then be stored separately for each band selected under 3.2.1. For each band a maximum of six stations can be stored.
AST function:
With the AST function you have the possibility to find and to store the six strongest stations of the FM or the MW band by means of one simple push on the button. This function can be called up as follows:
- Select the FM or the MW band as described under 3.2.1.
- Push and hold the AST button for approx. 2 seconds until a signal tone can be heard. Now the AST function starts to work. During the station search the message “STORE“ is displayed.
After a few seconds the station search and memory is finished. The stations which have been found are stored under “AST“ separately for the selected frequency range. This has no influence on the stations which are stored under “F1“,“F2“ or “MW“. After completion you can quit the AST range by pushing the BAND button.
Push AST for approx. 2 sec. until signal can be heard; “STORE“ is displayed
S
t e p 1
Quit the AST range
S t ep 2
3 Detailed instructions
Calling up the stations memorized as above:
-Activate the memory positions on which the programmes of the selected frequency range have been stored by means of a short push on the AST button.
-The six programmes stored can be called up by pushing the buttons 1
- 6
Shortly push AST
AST | AF TP PTY |
| S |
| t |
REG | e |
| p |
| 1 |
Select the desired programme
S t ep 2
Automatic station search:
The TechniSat WERRA 1 is equipped with an automatic station search system which stops on the first station received after starting.The reception range which has just been selected is searched through.
The searching sensitivity can be switched by the LOC button. Adjusting the searching sensitivity:
-By a short push on the LOC button you can switch the searching sensitivity between “local“ (display on device: “LOC“) and “normal“.
S
t e p 1 ASTAF TP 
PTY
REG
Shortly push LOC
When set to“local“ the automatic station search stops only at stations which can strongly be received. If no station can be found the function will automatically switch to normal searching sensitivity.
12