3Detailed instructions
3.1.4Loudness function
When the volume is low the human ear perceives bass notes worse than middle or high notes.In order to neutralize this effect the unit is equipped with a loudness function increasing the loudness of the bass notes electronically.
This function can be switched on resp. off as follows:
-Push the LOUD button once to switch on.
-To switch off, push the LOUD button once more
When loudness is switched on the letters “LOUD“ are shown on the display.
The loudness function can also be switched on/off permanently if you proceed as follows:
-Push the SEL button for more than 4 seconds.
The letters “2 SPKRS“ or “4 SPKRS“ are indicated on the display.
- Push the >> button once.
The message “LOUD ON“ or “LOUD OFF“ is displayed, depending if the function is switched on or off.
-Push the BAND button to switch the function on or off. The selected state is shown on the display.
After approx. 6 seconds the device changes to normal operation again. The modification is now stored.
| tep | 3 | Push once |
tep | S | to select | |
2 |
| ||
S |
| function | |
|
|
|
Press for more than 4 sec.
1 p e
t
S
Switch on/off loudness
Switch on/off function
S t ep 4
3Detailed instructions
3.1.5Calling the basic settings
By using the reset function the modifications according to chapter 3.1.3 can be removed with one single push. The settings are then set to a mean value. Furthermore, a loudness which may have been switched on is now being switched off.
To carry out the reset proceed as follows:
-Push the LOUD button for approx. 4 seconds until “RESET“ appears on the display.
The function described above is thus effected.
1 p e
t
S
Push for approx. 4 sec.
3.1.6 Mode switching
When a cassette is inserted the mode automatically changes to cassette operation. As described below you can change between radio and cassette. Consequently, when you want to listen to the radio the cassette may stay in the cassette slot. If a CD changer is connected you can also select this one. To change the operating mode carry out the following step:
-Push the MODE button, probably several times, until the desired operation mode is set.
AST | AF TP | PTY |
REG
Push once or several times
S t ep 1
8