TechniSat Car Radio manual Station search by programme type, Scan function

Page 14

3 Detailed instructions

A short push on the respective button will change the frequency by 0.05 MHz; when the button is pushed and held for a longer time the frequency runs until the button is released.

Storing the station:

-Store the station as described in the chapter “Automatic station search“.

Station search by programme type

Some stations with RDS also broadcast an identification of the programme type (e.g. CLASSIC, POP, ...). Thanks to this function it is possible to search for stations of a special programme type:

3 Detailed instructions

The TechniSat WERRA 1 is now searching for a station with the same programme type. It stops on the first station which corresponds to the selected programme type.

If no station can be found within the selected programme type the station which has been selected before will be adjusted.

-The station which has been found can then be stored for the selected frequency range as described under “Automatic station search“.

-

Shortly push the

PTY

button.

 

The programme type of the adjusted station is displayed. The indication

 

“NO PTY“ means that this programme does not broadcast any

 

programme type identification.

-

Push the buttons

<<

or >> possibly several times, to set the desired

 

programme type.

 

-

Push the PTY button for approx. 2 seconds until a signal tone can be

 

heard.

 

 

SCAN function:

AST

AF TP

PTY

REG

Select the desired programme position; push button until signal tone can be heard

S t ep 1

tep

2

S

Select the programme type

Shortly push

PTY

 

S

 

t

 

e

 

p

 

1

 

Hold PTY for

 

approx. 2 sec.

S t ep 3

until signal can

 

be heard

Thanks to the SCAN function it is possible to get a general idea of the stations which can be received at that time. After activating this function the adjusted reception range (see 3.2.1) will be searched through. The frequency run stops on every station which can be found and reproduces each station for 6 seconds.

Activation:

-Shortly push the SCAN button.

“SCAN“ is shown on the display and the function starts to work.

Finishing:

-Shortly push the SCAN button again.

The device is now tuned to the station which has been received before. This one can then be stored as described under “Automatic Tuning

System“.

14

Image 14
Contents Werra Traffic Announcement System Fast FORWARD/FAST Rewind Contents IntroductionMedium wave Switching on/off Operation2Volume control Sound controlLoudness function Calling the basic settingsMode switching Security code Entering the codeSwitching on/off the security code Adjusting the number of connected loudspeakers1Adjusting the reception range Radio unitAutomatic station search Station search/station memoryAST function Manual station search Station search by programme type Scan functionAutomatic Traffic Announcement System RDS functions Stereo/mono switching Display switchingChanging the track/auto reverse Cassette unitInserting/ejecting a cassette 3Fast Forward/RewindAMS Automatic Music Search function Tape type adjustmentDolby B noise suppression 2Operation CD changer1Connection Titles on the present CD Connection Additional functionsGeneral Technical dataAudio amplifier unit Quality Made in Germany