Falcon F110 manual Switched Sensor Alarm Configuration, Security

3 F110 Web Interface

Figure 3.6 Sensor Settings

3.3.5 Switched Sensor Alarm Configuration

The Channel 1 tab is used to configure sensor labels and alarm states (normally open or closed) for the eight (8) switch sensor ports (dry contact inputs) on the back of the F110 unit. Sensor labels can be up to 15 characters in length.

Alert Thresholds for switch sensors connected to the eight (8) sensor ports on the back of the F110 are set by specifying either CLOSED or OPEN. Please refer to the documentation received with any sensor purchased to determine the 'normal' state (open or closed) for that specific sensor type. Next, select the opposite state (i.e. not normal) to configure the F110 for its alarm state, which will cause it to send an alert when the alarm condition exists.

3.3.6 Security

The Security tab is used to configure password security for access to the F110 Settings Screen. Passwords can ONLY contain the alphanumeric characters “0-9”,”'a-z” and “A-Z”. Spaces, symbols, and punctuation are not supported. Be sure to record the password entered here in a secure location.

www.rletech.com 25 970.484.6510