1
OPERATING FEATURES
| ) |
|
> | Thls feature is avalabe only when a telephone inter- | |
|
| connect ID code IS selected. If a busy tone sounds |
|
| when the PTT button IS pressed, the transceiver enters |
|
| this mode automat~cally. |
|
| When the PTT button is released, a beep sounds for |
|
| 400ms to indicate that the mode has been entered. If |
|
| the scan IS on, it is resumed (the amark goes on.) |
|
| When any repeater becomes available, a ringing tone |
|
| s o ~ ~ n ands this mode ends. |
|
| The mode is terminated when the system, group, |
|
| scan, P n , or AUX key is changed. |
|
|
|
|
| Th~sfeature can be programmed to automat~cally |
| 1 | access other programmed systems when the selected |
| system cannot be accessed If an Intercept tone | |
| sounds when the PTT button IS pressed after setting | |
| the moae, the transcelver has entered the mode | |
|
| |
| c | If the group ID IS a telephone Interconnect ID, the |
|
| transcelver then attempts t o access, In succession, |
| [ | other systems that have a telephone tnterconnect ID in |
| the revert group locatlon If the group ID IS a dlspatch | |
| g | ID, the transcelver attempts to access other systems |
|
| |
|
| that have a dlspatch ID programmed In the revert |
|
| group locatlon |
|
| If there IS no system to be accessed, an Intercept |
|
| tone sbunds, the mode IS termlnated, and the trans- |
|
| celver returns to the flrst system If the access IS suc- |
|
| cessful, the mode IS termlnated, and the searched sys- |
|
| tem becomes the new selected system (If durrng |
|
| scannlng, the scan stops ) |
|
|
|
3-17. Preferred System Revert
This feature is available by assigning this feature to the AUX (Aux~liary)key The feature is used to move the revert system/group to the fixed programmed sys- temlgroup qu~ckly. When the AUX key I S pressed during scanning, the scan stops temporarily, and the revert systemlgroup is displayed. The scan resumes about one second after the AUX key is released.
3-18. Alphanumeric Display Select
The systemlgroup number display and the alphanu- meric display can be switched with the AUX key by assigning this feature to the key. Figure 2 shows the characters that can be displayed. These are basic char- acters, and can be displayed in each segment. Four digits can be displayed at the same time.
I 7 71- | ||
I l l I I | I I , | |
II | 1 - 1 |
A B C D E F G H I
J K L M N O P Q R
S T U V W X Y Z
Thts feature can be programmed to turn on and off each group. If the ID of the group for which trans- d IS enabled is received, t w o data messages (trans- ID and
mmed to turn on or off for button is pressed for the nd feature is set, the home r transmission, and the re- rformed. Signaling must
- ; | Fig. 2 |