Clarion VRX775VD owner manual Basic Operations

Page 34

DVD Video Player Operations

English Owner’s manual

The relationship between DVD video category codes and parental level are shown in the table below. Use this table when setting the parental level.

LEVEL7

NC-17

 

(NO ONE 17 AND UNDER

 

ADMITTED)

 

 

LEVEL6

R

 

(RESTRICTED)

 

 

LEVEL4

PG-13

 

(PARENTS STRONGLY

 

CAUTIONED)

 

 

LEVEL3

PG

 

(PARENTAL GUIDANCE

 

SUGGESTED)

 

 

LEVEL1

G

 

(GENERAL AUDIENCES)

 

 

The contents that the parental level restricts vary with the country code.

WARNING

Some videos may be recorded at higher than desired volume levels. Increase the volume gradually from the minimal setting after the video has started.

For your safety, the driver should not watch the video or operate the controls while driving. Please note that watching and operating the video while driving are prohibited by law in some countries.

Note:

For your safety, the VRX775VD has a safety function which turns off the picture when the car is moving, so only the audio can be heard. The picture can only be watched when the car is stopped and the parking brake is applied.

If “AUDIO ONLY” appears on the screen just after turning on the ACC power of the car, release the parking brake while confirming safety, and then engage the parking brake again.

Basic Operations

Loading a disc

1.Insert a disc into the center of the insertion slot with the label side facing up. The disc plays automatically after loading.

Note:

Never insert foreign objects into the disc insertion slot.

If the disc is not inserted easily, there may be another disc in the mechanism or the unit may require service.

8 cm (single play) discs cannot be used.

CAUTION

With the screen open, a driver may not be able to see the disc insertion slot. For your safety, insert a disc with the screen closed.

Pausing play

1.Press the [p] button or touch the [p] key to pause play.

PAUSE” appears in the display.

2.To resume disc play, press the [p] button again.

Ejecting a disc

1.Press the [o] (EJECT) button to eject disc. “EJECT” appears in the display. The play mode then switches to the TUNER mode.

*If a disc is left in the ejected position for 15 seconds, the disc is automatically reloaded (Auto reload). In this case, however, the play mode will remain set to the TUNER mode.

Note:

If you force a disc into before auto reloading, this can damage the disc.

Watching/Listening to a disc already inserted

1.Press the [SRC] button, and touch the [DVD PLAYER] key to select the DVD PLAYER mode.

Play starts automatically.

If no disc is loaded in the unit, “NO DISC” appears in the display.

36 VRX775VD

Image 34
Contents VRX775VD Contents Precautions FeaturesExpanding Systems MAP Menu NomenclatureEnglish Names of Buttons ISRTurning the power on OpenEnters desired frequency Tuner mode operationKey Pad screen Preset List screen Selects desired stationWhen automobile moving DVD Video mode operationDVD Player mode screen∗4 DVD Setup menuBAL/FAD Adjusting audio feature settingsBAL/FAD screen Status Speaker SEL Status screen Speaker SEL menuMonitor ADJ Adjusting the other system settingsWall Color Remote control unit Remote ControlInserting the Batteries DVD Player mode Functions of Remote Control Unit ButtonsTUNER/TV/Satellite Radio mode Shared modesIPod mode Functions of Remote Control Unit ButtonsCD changer mode When SUB zone is selected DVD changer modeAttaching the DCP Remote control unit cannot be used when the DCP is removedRemoving the DCP Pull the left side of the DCP toward you, and remove itCleaning the liquid crystal panel CleaningCleaning the cabinet Liquid crystal panel/GeneralitiesHandling Discs DVD Video Features DVD Video SystemDiscs About the registered marks etcOperations Selecting a modeTurning on and off the power Basic OperationsAdjusting the volume Opening and turning the liquid crystal panelHousing the liquid crystal panel Adjusting the AudioPress the ADJ button, then touch the Audio key Adjusting the MID Basic Operations Adjusting the balance/faderAdjusting the Bass Adjusting the TrebleAdjusting the Monitor Adjusting the brightness, color, hue and dimmer levelAdjusting the General Switching Connect connect Cellular phone interrupt settingSetting the voice input line for the cellular phone Basic Operations Performing the system checkSetting the time of air conditioner operation mode Adjusting the ClockBasic Operations Setting the Auto Panel Normal operationZone Function Setting the 2-ZONE functionAbout the 2-ZONE function Basic Operations Monitor image and sound with 2-ZONE ON/OFF Radio Operations Seek tuningManual tuning Listening to the radio Auto store Radio Operations Recalling a preset station Preset scan Manual memorySelecting the DVD Setup menu Changing DVD System SettingsSetting up the screen size Setting up the angle mark displaySetting up the country code Setting up the audio languageSetting up the subtitle language Setting up the parental levelBasic Operations Operating the DVD menu DVD Video OperationsWatching a DVD-Video Showing the DVD menuSkipping a chapter searching Pausing playbackDVD Video Player Operations Stopping playback Slow playbackRepeat playback Using the title menuScan playback TOP functionSwitching angles DVD Video Player Operations Switching among languagesSwitching subtitles Displaying the playback statusSkipping a track searching Watching a video CDShowing the V-CD menu for Video CD discs with PBC On/Off of Playback Control Listening to a CDDVD Video Player Operations Searching with a track number Changing audio outputOther various play functions DVD Video Player Operations TOP functionSelecting a track on the Track List screen Displaying CD titlesListening to an MP3/WMA What is MP3/WMA?Precautions when creating an MP3 disc Displaying MP3/WMA TAG titlesSelecting a folder/track on the List screen Playback by selecting a folder and track Direct select modeTouch the Back key to return to the Folder List screen DVD Video Player Operations Other various play functions Title list play Other FunctionsEntering titles TunerFactory default setting is F.WIDE Internal amplifier cancel functionOther Functions Changing over monitor display size IPod Operations Operations of AccessoriesControlling the iPod IPod Operations TOP function Fast forward and fast backwardSelecting a list item from a list screen Visual Operations CD Changer OperationsSearching with a track number DVD Changer Operations TV OperationsUsing the Preset List screen TV Operations Selecting with a channel numberTV Operations Preset scan Setting the TV diverSatellite Radio Operations Tuning mode T-MODE Receiving stations selected by categoryScan function Satellite Radio Operations Presetting a categoryPreset scan Category scanningNavi functions Setting Navi as external input equipmentNavi Operations Navi operationNavi Operations Connecting Other Company’s Image Equipment Changing displayCh Surround Decoder control function DimensionCh Surround Decoder Operations PanoramaCh Surround Decoder Operations DSF mode EQ modeSubwoofer volume adjustment Balance/Fader adjustmentCenter volume adjustment Case of Difficulty Problem Cause MeasureSee the subsection Setting up the parental DVD PlayerTV/VTR When connecting an optional TV tuner, etc Connected, Setting Image is disturbedError Displays CD ChangerSpecifications Installation and Wire Connection Manual Install the unit within 30 of the horizontal plane. Figure Installing the Main Unit Universal MountScrew Removing the Main Unit CCA-670 CCA-673Ground +12V main powerRear right +12V accessory Front right + Front left + Rear right +Connecting the parking brake cord Connecting the AccessoriesNavigation System NAX970HD Front Powered subwooferVideo Selector Speakers2006/12 Y-YI QC-6824B