Alesis 12R manual Phonograph turntables

Page 23

Connections

Phonograph turntables

If you're using a record turntable, you may not plug it directly into the line inputs of the Multimix 12R (well, you can, but it will sound very thin and noisy). Obtain a phono preamp from your dealer or an electronics specialty store.

1.Plug the outputs of the phonograph pickup into the RIAA- equalized phono preamp.

2.Plug the outputs of the preamp into the LINE IN 9-10 or 11-12 inputs of the Multimix 12R.

Do not connect any of the following to any input of the Multimix 12R!

The speaker output of any power amplifier.

Any source that is too loud for the input (no more than 3 volts RMS into a [MIC] jack or 13 volts RMS into a [LINE IN] jack).

Any unshielded cable.

Multimix 12R Reference Manual

13

Image 23
Contents Reference Manual Page Important Safety Instructions Page Page Page Page Page CE Declaration Of Conformity Front Panel Table of Contents Applications Dimensional DrawingConventions Using this manualIntroduction Alesis Multimix 12R Microphone Preamplifier/MixerGrounding Instructions Unpacking InstallationAC power Mounting Use clean powerPower switch Cable common sense ConnectionsInputs Microphone Inputs Phantom power Line-level devices synthesizers, CD players, video Phantom Power will not be Used Tape in jacks Phonograph turntables About stereo effect devices How to connect effect devices and signal processorsEffects via Aux Send and Aux Return Using Aux 1 as an effects send Connecting an in-line processor Connections To a stage monitor foldback system OutputsTo a stereo PA system or instrument amplifier To a mono systemTo a stereo tape recorder To another mixerIn-line Adat recording To an Adat multitrack recorderUsing two Multimix 12Rs for more flexibility Connections Monitor Out PhonesConnections Before turning the mixer on, zero out the controls Operating InstructionsPeak LED method Setting input trim levelsMetering/Unity Gain method Aux Send levels Typical Fader and Control LevelsUnity gain points Trim gain rangesProper gain staging of other equipment AUX System Effects Send/Receive How to Set Aux Send and Return LevelsPage Output distortion Using the meterSystem noise ground loops, hum, induced noise Avoiding noise① to Eliminate HUM if the Above has Failed Page Operating Instructions Tracking/Overdubbing ApplicationsMultitrack recording Mixdown Using the High and LOW EQ controls Monitoring AUX 1 in the Phones jack Troubleshooting Index TroubleshootingPage Refer All Servicing to Qualified Technicians Maintenance/ServiceExterior cleaning Frequency Response SpecificationsConnectors Impedance LevelsDistortion THD+N PowerNoise performance typical Dimensional Drawing Block Diagram Level diagram Tape IndexWarranty / Contact Alesis Contact Information