Alesis 12R manual Connecting an in-line processor

Page 26

Connections

(the ring of a TRS plug). A special Y-cable consisting of a TRS 1/4" plug on one end and two mono 1/4" plugs on the other end is required.

Insert Points

Send

Return

Ground

Tip

Ring

Tip

Ring

Sleeve

Sleeve

Note that you will not hear any signal through the Multimix 12R if the INSERT jack is plugged in and the signal is interrupted in that loop (by the other cables being disconnected, the processor being turned off, or the volume turned off in the processor).

Connecting an in-line processor

1.Obtain a "stereo splitter" insert cable from your dealer.

2.Connect the stereo (TRS) end to the INSERT jack of the Multimix 12R.

3.Connect the mono plug from the tip connector to the input of the processor.

4.Connect the mono plug from the ring connector to the output of the processor.

If you're not sure which mono plug is from the tip and which is from the ring, check to see if the cable is labeled. If not, simply try it one way and if the signal doesn't pass through, swap the input and output plugs the other way.

The [INSERT] jack may also be used as a direct output to a multitrack recorder such as the ADAT. The send from the insert jack is where the cleanest mic preamp signal may be obtained, without passing through the EQ or channel circuitry. Simply insert the plug to the first "click" (the ring connector) and it will not interrupt the flow through the mixer, while

Image 26
Contents Reference Manual Page Important Safety Instructions Page Page Page Page Page CE Declaration Of Conformity Front Panel Table of Contents Dimensional Drawing ApplicationsAlesis Multimix 12R Microphone Preamplifier/Mixer Using this manualIntroduction ConventionsGrounding Instructions Unpacking InstallationAC power Mounting Use clean powerPower switch Cable common sense ConnectionsInputs Microphone Inputs Phantom power Line-level devices synthesizers, CD players, video Phantom Power will not be Used Tape in jacks Phonograph turntables About stereo effect devices How to connect effect devices and signal processorsEffects via Aux Send and Aux Return Using Aux 1 as an effects send Connecting an in-line processor Connections To a mono system OutputsTo a stereo PA system or instrument amplifier To a stage monitor foldback systemTo another mixer To a stereo tape recorderTo an Adat multitrack recorder In-line Adat recordingUsing two Multimix 12Rs for more flexibility Connections Phones Monitor OutConnections Operating Instructions Before turning the mixer on, zero out the controlsSetting input trim levels Peak LED methodMetering/Unity Gain method Trim gain ranges Typical Fader and Control LevelsUnity gain points Aux Send levelsProper gain staging of other equipment How to Set Aux Send and Return Levels AUX System Effects Send/ReceivePage Using the meter Output distortionAvoiding noise System noise ground loops, hum, induced noise① to Eliminate HUM if the Above has Failed Page Operating Instructions Tracking/Overdubbing ApplicationsMultitrack recording Mixdown Using the High and LOW EQ controls Monitoring AUX 1 in the Phones jack Troubleshooting Troubleshooting IndexPage Refer All Servicing to Qualified Technicians Maintenance/ServiceExterior cleaning Frequency Response SpecificationsConnectors Levels ImpedanceDistortion THD+N PowerNoise performance typical Dimensional Drawing Block Diagram Level diagram Index TapeWarranty / Contact Alesis Contact Information