Alesis 12R manual Connections

Page 32

Connections

Because the ADAT has normalled inputs, the stereo output of the source mixer may be recorded on other tracks without repatching. The left output of the mixer will appear at the inputs of tracks 1, 3, 5 & 7; the right output will appear at track 2, 4, 6 & 8. On the ADAT-XT, press and hold [ANALOG INPUT] and the REC READY keys for track 1 or 2 to activate this "built-in patch bay" feature.

2.Plug track outputs 1-8 of the ADAT to LINE IN 1-8 of the "monitor/mixdown" 12R. Note that output 1 is on the left of the ADAT, but on the right of the mixer, so the wires must cross over.

3.To record more than two tracks at a time, plug a mono cable from the INSERT jack of any channels of the mixer to the input of any track. By plugging the cable all the way in the INSERT jack, and not returning the signal from the recorder, the individual channels will be removed from the stereo mix. This way, you can record a stereo mix of several inputs on any two tracks while simultaneously recording individual sources on other tracks.

Image 32
Contents Reference Manual Page Important Safety Instructions Page Page Page Page Page CE Declaration Of Conformity Front Panel Table of Contents Dimensional Drawing ApplicationsUsing this manual IntroductionAlesis Multimix 12R Microphone Preamplifier/Mixer ConventionsGrounding Instructions Unpacking InstallationAC power Mounting Use clean powerPower switch Cable common sense ConnectionsInputs Microphone Inputs Phantom power Line-level devices synthesizers, CD players, video Phantom Power will not be Used Tape in jacks Phonograph turntables About stereo effect devices How to connect effect devices and signal processorsEffects via Aux Send and Aux Return Using Aux 1 as an effects send Connecting an in-line processor Connections Outputs To a stereo PA system or instrument amplifierTo a mono system To a stage monitor foldback systemTo another mixer To a stereo tape recorderTo an Adat multitrack recorder In-line Adat recordingUsing two Multimix 12Rs for more flexibility Connections Phones Monitor OutConnections Operating Instructions Before turning the mixer on, zero out the controlsSetting input trim levels Peak LED methodMetering/Unity Gain method Typical Fader and Control Levels Unity gain pointsTrim gain ranges Aux Send levelsProper gain staging of other equipment How to Set Aux Send and Return Levels AUX System Effects Send/ReceivePage Using the meter Output distortionAvoiding noise System noise ground loops, hum, induced noise① to Eliminate HUM if the Above has Failed Page Operating Instructions Tracking/Overdubbing ApplicationsMultitrack recording Mixdown Using the High and LOW EQ controls Monitoring AUX 1 in the Phones jack Troubleshooting Troubleshooting IndexPage Refer All Servicing to Qualified Technicians Maintenance/ServiceExterior cleaning Frequency Response SpecificationsConnectors Levels ImpedanceDistortion THD+N PowerNoise performance typical Dimensional Drawing Block Diagram Level diagram Index TapeWarranty / Contact Alesis Contact Information