Kenwood TH-D7A Basic Transceiver Modes, Function Select mode, VFO mode, Memory Recall mode

BASIC TRANSCEIVER MODES	Function Select mode
This section introduces you to the basic modes you can	Press [F] to select. In this mode you can scroll F–1			1
	through F–8 (except F–6) by pressing [UP]/ [DWN]; to
select on this transceiver.				2
	access F–6, first select the 118 MHz band {page 51}.
VFO mode
	After accessing the desired function, press [OK], then			3
	press [UP]/ [DWN] to select the desired parameter.
Press [VFO] to select. In this mode you can change the				4
	Last, press [OK] again to complete the setting. After
operating frequency by pressing [UP]/ [DWN] or entering
	recalling a memory channel, you can also access F–0			5
digits directly from the keypad {page 45}.
	and F–9. On the TH-D7E you cannot access F–6.			6
		STA CON PACKET96 BCONDUP		7
	5	7	9	8
				9
				10
Memory Recall mode	Pressing [F], [0] ~ [9] is a much simpler method than the			11
Press [MR] to select. In this mode you can recall the				12
	above. For example, pressing [F], [1] switches the Tone
desired memory channel by pressing [UP]/ [DWN] or	function ON or OFF. This method is described in the			13
entering digits directly from the keypad {page 28}. For	appropriate sections in this manual.			14
further information, refer to “MEMORY CHANNELS”
	Menu mode			15
{page 26}.
	Press [MENU] to select. In this mode you can access			16
	the desired menu item by pressing [UP]/ [DWN] and			17
	[OK] or entering digits directly from the keypad. For
				18
	further information, refer to “MENU SET-UP” {page 16}.
				19
		STA CON PACKET96 BCONDUP		20
	5	7	9
				21
				22
				23

13