Kenwood TH-D7A instruction manual Up/ Dwn, Power, Mode, Clr, Fast, Sync, Ent

CONTROL OPERATION

When in the Sky Command mode, the keys of the Commander will function as below. Only the functions of [LAMP], [MONI], and the VOL control will not change. First switch ON the HF transceiver and press [SYNC] on the Commander.

Tuning

control

Each time you press the desired key, the Commander will automatically enter transmit mode and send the corresponding control command to the Transporter.

To switch ON/ OFF the HF	Press [POWER].
transceiver
To transmit audio on a HF	Press and hold the PTT
	switch, then speak into the
frequency
	microphone.
To receive audio on a HF	Press [RX].
frequency
To monitor the UHF band	Press and hold [MONI].
on the Commander

Key	Function
Tuning	Frequency or memory channel number
control	change
UP/ DWN	RIT offset or XIT offset change
A/B	In VFO mode: VFO A/ VFO B switch
	In Memory Recall mode: no change
POWER 1	Power ON/ OFF
RX 1	HF frequency receive ON/ OFF
MODE 1	Modulation mode switch
RIT 1	RIT ON/ OFF
XIT 1	XIT ON/ OFF
CLR 1	RIT offset or XIT offset clear
SPLIT 1	Split-frequency ON/ OFF
M ➧ V 1	Transfer from Memory to VFO
FAST	In LSB, USB, or CW mode: 10 Hz/ 1 kHz
	switch
	In FM or AM mode: 1 kHz/ 10 kHz switch
SYNC 1	Current settings retrieve (from HF
	transceiver)
ENT	In VFO mode: frequency entry ON
	In Memory Recall mode: channel number
	entry ON
M/V	VFO/ Memory Recall mode switch

1After pressing [ENT], you can use these keys as numeric keys to enter a frequency or memory channel number.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

87