Kenwood TH-D7A Recalling a Memory Channel, Clearing a Memory Channel, Press MR+ Power on

• You cannot recall an empty memory channel.

RECALLING A MEMORY CHANNEL

11 Select the desired band.

22 Press [MR] to enter Memory Recall mode.

3• The memory channel used last is recalled.

4

5

6

7

8

3 Press [UP]/ [DWN] to select the desired memory

9

channel.

10

11• To restore VFO mode, press [VFO].

12You can also recall a memory channel by direct entry

13from the keypad. In Memory Recall mode press [ENT],

14then enter the channel number. To recall channel 3, for

15example, press [ENT], [0], [0], [3].

Note:

16◆ When you recall an odd-split memory channel, “+” and “–” appear on

17the display. Press [REV] to display the transmit frequency.

◆After recalling a memory channel, you may program data such as

18Tone or CTCSS. These settings, however, are cleared once you select another channel or the VFO mode. To permanently store the

19data, overwrite the channel contents {page 27}.

20

21

22

23

CLEARING A MEMORY CHANNEL

Use the following procedure to clear an individual memory channel. Full Reset {page 32} is a quick way to clear all memory channels.

1Recall the desired memory channel.

2Switch OFF the power to the transceiver.

3Press [MR]+ POWER ON.

• A confirmation message appears.

• To quit clearing the memory channel, press [ESC].

4Press [MR] again.

• The contents of the memory channel are erased.

Note: If you have recalled a memory channel on the non-current band (A or B), you cannot select the same channel on the current band to clear.

28