Kenwood TH-D7A Programming Offset, Press UP/ DWN to select the appropriate offset Frequency

PROGRAMMING OFFSET ■ Selecting Offset Frequency

First select band A or B by pressing [A/B]. Then, if necessary, press [F], [A/B] to recall the sub-band.

■Selecting Offset Direction

Select whether the transmit frequency will be higher

(+)or lower (–) than the receive frequency. Press [F], [MHz] to switch the offset direction.

To access a repeater which requires an odd-split frequency pair, change the offset frequency from the default which is used by most repeaters. The default offset frequency on the VHF band is 600 kHz no matter which market version; the default on the UHF band is 5 MHz (TH-D7A) or 1.6 MHz (TH-D7E).

1Press [F], [5] to select “F–5 (OFFSET)”.

1

2

3

4

5

6

• “+” or “–” appears to indicate which offset direction is					STA CON PACKET96 BCONDUP		7
selected.				5	7	9	8
	STA CON PACKET96 BCONDUP						9
5	7	9					10
				2 Press [UP]/ [DWN] to select the appropriate offset			11
				frequency.			12
• To program –7.6 MHz offset on the TH-D7E (UHF only),				• The selectable range is from 0.00 MHz to 29.95 MHz			13
				in steps of 50 kHz.			14
repeatedly press [F], [MHz] until “			” appears.
If the offset transmit frequency falls outside the				3 Press [OK] to complete the setting.			15
allowable range, transmitting is inhibited. Use one of				TH-D7E Only: If you have selected “		” for the offset direction, you	16
the following methods to bring the transmit frequency				cannot change the default (7.6 MHz).			17
within the band limits:				Note: After changing the offset frequency, the new offset frequency
							18
• Move the receive frequency further inside the band.				will also be used by Automatic Repeater Offset.
• Change the offset direction.							19
Note: While using an odd-split memory channel or transmitting, you							20
cannot change the offset direction.							21
							22
							23

21