Pioneer XDV-P9II owner manual If You Forget Your Code Number, Error Message, Message error number

Others

If You Forget Your Code Number

Refer to “Changing the Level”, step 3 on page 46, and press the CLEAR button 10 times. The registered code number is canceled, letting you register a new one.

Error Message

When problems occur with disc playback, an error message appears on the display. Refer to the table below to identify the problem, then take the suggested corrective action. If the error persists, contact your dealer or your nearest PIONEER Service Center.

Message (error number)	When this message is displayed	Remedy
Error-2	The disc is dirty.	Wipe the disc clean. (See page
		13.)
	The disc is scratched.	If the disc is scratched, replace it
		with another. (See page 13.)
	The disc is loaded upside down.	Check that the disc is loaded
		correctly. (See page 14.)
	This type of disc (CD-ROM etc.)	Replace the disc with one this
	cannot be played by this unit.	unit can play. (See page 9.)
Error-5	This unit’s power supply or	Switch this unit OFF and then
Error-6	internal mechanisms may be	switch it back ON. (See page
	malfunctioning.	17.)
No Disc	There are no discs loaded in the	Load a disc or discs in the maga-
	magazine.	zine. (See page 14.)
Thermal Protection	The temperature of this unit is	Wait until the unit’s temperature
	outside of the normal operating	returns to within normal operat-
	range.	ing limits.
DVD Player Door Open	The DVD player’s door is open.	Close the DVD player’s door.
CANNOT BE PLAYED	The disc does not have the same	Replace the DVD with one bear-
	region number as this unit.	ing the correct region number.
	This type of disc (CD-ROM etc.)	Replace the disc with one this
	cannot be played by this unit.	unit can play. (See page 9.)

59