Installation
Note:
•Before finally installing the unit, connect the wiring temporarily, making sure it is all con- nected up properly, and the unit and the system work properly.
•Use only the parts included with the unit to ensure proper installation. The use of unautho- rized parts can cause malfunctions.
•Consult with your nearest dealer if installation requires the drilling of holes or other modifica- tions of the vehicle.
•Install the unit where it does not get in the dri- ver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
•When mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings.
•Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it.
•Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electri- cal wiring or other important parts.
•If this unit is installed in the passenger com- partment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident.
•If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit.
•Do not mount this unit on the spare tire board or any other unstable place.
•Do not mount this unit anywhere that gets the sun and so becomes hot, like on the dashboard or the rear shelf.
•Mount this unit on a flat surface.
•Installations in other than the horizontal or ver- tical positions indicated will prevent this prod- uct from performing correctly or could cause malfunction.
MODE Switch Setting
Before installing, use a pen tip or other thin, pointed instrument to set the MODE Switch to the appropriate position for the compo- nent you are using it with.
STAND
Installation
72