Hitachi hitachi lcd monitor Operating Instructions, Turning Power On and Off, Indicating lamp

OPERATING INSTRUCTIONS

Indicating lamp

Main power switch

SUB-POWER button

POWER button

Turning Power On and Off			ENGLISH
• To turn the monitor power ON, press the main power
switch on the monitor main unit to ON, and then press the
SUB POWER button of control panel or the POWER button
on the remote control.
• To turn the monitor power OFF, press the SUB POWER
button of control panel or the POWER button on the
remote control, and then press the main power switch on
the monitor main unit to OFF.
• During normal use, the main power switch is set in the ON
position, and the monitor can then be turned ON/OFF using the
SUB POWER button or the POWER button on the remote
control.
Indicating lamp
Indicating	Power	Operating
lamp	status
Off	Off	When the main power switch is set to
		OFF.
		When the main power switch is ON, and
Lights red	Off	the POWER button on the remote control
	(standby)	or the SUB POWER button on the upside
		of the monitor is OFF.
		When the main power switch is ON, and
Lights green	On	the POWER button on the remote control
		or the SUB POWER button on the upside
		of the monitor is ON.
		When the main power switch is ON, and
		the POWER button on the remote control
Lights orange	Off	or the SUB POWER button on the upside
	(Power Save)	of the monitor is ON.
		However, the state is in POWER SAVE
		mode.(RGB 1 and RGB 2 only.)

When the indicating lamp lights in orange or the message “No Sync. Signal”, “Power Save” or “Invalid Scan Freq.” appears on the screen, there is something unusual about the status of reception. See “Power Save Mode” or “Symptoms That Seemingly Appear to be Failures.” 43 44 45

ATTENTION

•Avoid repeatedly turning the monitor on and off at short time intervals. Failures might result from such operation.

•Turn off the main power switch before leaving the monitor out of use for an extended period of time.

•If a power failure occurs while the main unit is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the main unit.

19