Hitachi hitachi lcd monitor user manual Frequency Mode, Vertical Filter

OPERATING INSTRUCTIONS (continued)

SETUP MENU (RGB mode: RGB1 (DVI-PC), RGB2 (RGB)) (continued)

Selected characters			Setup hint
Vertical Filter		Turn On when concerned about screen flicker.
Frequency Mode	Grayed out	This function is not available.
RGB1		This should correspond to the signal mode of the signal from the
		equipment that is connected to RGB1 DVI terminal.
RGB2 (1st step)		This should correspond to the signal mode of the signal from the
		equipment that is connected to RGB2 D-sub terminal.
		This step should be set only when [Component] is selected on the
		1st step.
		This should correspond to the signal mode of the signal from the
RGB2 (2nd step)		equipment that is connected to RGB2 D-sub terminal.
		•	Normally, set this to Auto. The signal mode of the input signal
			will be automatically recognized.
		•	If the input signal contains much noise or has a low level at
			Auto and the operation is found erratic, set this to match the
			input signal.

* Depending on the type of signal displayed, displays may not be optimized through automatic adjustment. Adjust manually to optimize them.

ENGLISH

33