Hitachi hitachi lcd monitor Other Features DVD Player/STB Selection, Signal Check RGB mode

OTHER FEATURES (continued)

DVD Player/STB Selection (continued)

Set up hint
Example) HITACHI DVD
To operate HITACHI DVD player, press and hold the				button,
followed by the		button.
1.	Set up the maker
	Press button to indicate the DVD LED on the remote control.
	While the DVD LED is flashing, press		and .
2.	Set up the maker type
	Release the	button while keeping	button depressed.
	Then, press the	button.
3.	Confirm the setting
	After setting the maker and type, press the POWER button on the remote control.

If the DVD does not switch on, repeat step 1 and 2 using other maker types as listed in the chart on 43 .

NOTE

• Not all models of the listed makers can be operated using this remote control.

Signal Check (RGB mode)

Changes in the signal status are displayed on the screen as they arise.

Status	Display		Action
When Frequency Display is set to ON,	A guide is displayed for the input
the input signal is switched or when	terminal and the horizontal and
the RECALL button is pressed.	vertical sync frequency.
When the sync signal is no longer	• A guide displays No Sync. Signal,	Recheck the personal computer
detected.	and Power Save (for approx. 5 sec.)	power switch status and the
	• When the condition continues where	connection status.
	the sync signal cannot be detected,
	indicator lamp of power source
	changes in orange and the mode
	switches to power save mode.
When the input signal does not match	A guide displays Invalid Scan Freq.	Recheck the input signal
the monitor specifications or is in an		specifications. 50 ~ 52
unstable status.

RGB

! No Sync. Signal

!Invalid Scan. Freq.

44