Siemens HD2528U, HD2525U installation instructions Service, Important Safety Instructions

Page 4

!IMPORTANT SAFETY INSTRUCTIONS

WARNING

Before installing, turn power OFF at the service panel. Lock service panel to prevent power from being turned ON accidentally.

CAUTION

Unit is heavy and requires at least two persons or proper equipment to move.

CAUTION

Hidden surfaces may have sharp edges. Use caution when reaching behind or under appliance.

Installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1.

The appliance must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code ANSI/ NFPA 70, latest edition. (In Canada, installation must be in accordance with the CAN 1- B149.1 and .2 Installation Codes for Gas Burning Appliances and/ or local codes).

Remove all tape and packaging before using the range. Destroy the carton and plastic bags after unpacking the range. Never allow children to play with packagingmaterial.

Final Steps Installation Preparation Safety Instructions

Service

WARNING

Stepping, leaning or sitting on the doors or drawers of this range can result in serious injuries and also cause damage to the range. Do not allow children to climb or play around the range. The weight of a child on an open door may cause the range to tip, resulting in serious burns or other injury.

CAUTION

Do not use the oven or warming drawer (if equipped) for storage.

WARNING

Do not store items of interest to children in the cabinets above the range or on the backguard of a range. Children climbing on the range to reach items could be seriously injured.

This appliance complies with one or more of the following

Standards:

UL 858, The Standard for the Safety of Household Electric Ranges

UL 923, The Standard for the Safety of Microwave CookingAppliances

UL 507, The Standard for the Safety of Electric Fans

ANSI Z21.1-2000, The American National Standard for Household Cooking Gas Appliances

CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators

CAN/CSA-C22.2 No. 61-M89 Household Cooking Ranges

It is the responsibility of the owner and the installer to determine if additional requirements and/or standards apply to specific installations.

Be sure your appliance is properly installed and grounded by a qualified technician. Installation, electrical connections and grounding must comply with all applicable codes.

Install only per installation instructions included in the literature package for this range.

Ask your dealer to recommend a qualified technician and an authorized repair service.

Know how to disconnect the power to the range at the circuit breaker or fuse box in and the gas supply at the shutoff in case of an emergency.

Do not repair or replace any part of the appliance unless specifically recommended in the manuals. All other servicing should be done by a qualified technician. This may reduce the risk of personal injury and damage to the range.

When testing the supply piping system at test pressures in excess of 1/2 psig (3.5 kPa), the appliance and its indiviual shut-off valve must be disconnected from the gas piping system.

When testing the supply piping system at test pressures equal to or less than 1/2 psig

(3.5 kPa), the appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve.

Never modify or alter the construction of a range by removing leveling legs, panels, wire covers, anti-tip brackets/screws, or any other part of the product.

Do not lift door by door handle. Remove the door for easier handling and installation. See Section “Removing Oven Door” in Use and Care manual.

High Altitude Installation Note:

This range is CSA certified for safe operation up to an altitude of 10,000 ft. without any modifications. Exception: for use with LP, the range must first be converted using the LP conversion instructions included in this literature package.

Image 4
Contents Siemens Dual-Fuel Range With threeD Surround Convection Page Table of Contents Preparation Installation Final Steps ServiceRange Tipping Hazard Service Important Safety InstructionsSafety Instructions Preparation Installation Final Steps Installation Preparation Safety InstructionsTips Install Strain Relief Prepare Electrical ConnectionTIP Model HDS, HDInstallation Final Steps Installation Connect ElectricConnect the Range Cord Three Wire Connection Proceed to , nextInstallation Connect Gas Supply Flexible Connector Method see , thisRigid Pipe Method see , this Test for Gas LeaksTest the Installation Flame Characteristics8B. Test/Adjust Flame When Properly AdjustedBefore Calling Service Product Data PlatePage Table des matières Pièces FourniesAvertissement Pièces NécessairesService Étapes finales Installation Remarque pour installation à haute altitudePréparation Instructions de sécurité Instructions DE Sécurité ImportantesSécurité électrique Sécurité relative aux équipements à gazInstallation de la ventilation Installation de la fixation antibasculeÉtapes 1 à 4 Préparation Préparation des armoiresÉtapes finales Service Instructions deSécurité Étape 5 Préparation de la connexion électriqueService Étapes finales Installation Préparation Étape 6 Installation connexion électriqueInstructions de sécurité Connexion du cordon de la cuisinière Connexion à 3 filsInstructions de sécurité Préparation Installation Étape 7 Installation connexion de l’alimentation en gazDébit de gaz à l’appareil Passer à «Test de fuite de gaz», colonne suivanteInstallation Préparation Instructions de sécurité Service Étapes finalesPlaque signalétique Avant d’effectuer un appel de servicePlaque signalétique Page Seguridad Preparación Instalación Pasos FInales ServicioContenido LEA Y Guarde Estas Instrucciones Antes DE Usar Este AparatoInstrucciones Importantes DE Seguridad Advertencia Pasos Finales ServicioCuidado Seguridad Preparación Instalación Instrucciones Importantes DE SeguridadPreparación Seguridad Instalación Pasos Finales Servicio Instalación Pasos FInales Servicio Paso 5 Preparar la Conexión EléctricaConsejo Modelo HDS, HDConexión con Tres Hilos Conexión con Cuatro Hilos Preferido a tres hilosSeguridad Preparación Paso 7 Instalación Conectar el Suministro de GasVerificar Fugas de Gas Flujo de Gas a la EstufaInstalación Preparación Seguridad Finales PasosPaso 8 Probar la Instalación Características de las LlamasSeguridad Preparación Instalación Pasos FInales Servicio Antes de llamar al servicioPlaca con datos del pro-ducto Abra el cajón para verla
Related manuals
Manual 52 pages 52.85 Kb