Siemens HD2525U, HD2528U Preparation Installation Final Steps Service, Table of Contents

!Important Safety Instructions

	Table of Contents
ImportantSafetyInstructions	................................................................................................. 1
Preparation	4
Installation	6
Final Steps	8
Service	9

PLEASE READ AND SAVE ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.

Safety Instructions

PARTS PROVIDED:

Anti-Tip Bracket

TOOLS AND PARTS NEEDED:

•Range Power Supply Cord Kit with strain relief (240V - 30 Amps)*

•Standard Measuring Tape

•Phillips Head Screwdriver

•1-1/4” Wrench

•Pencil

•T-20 Torx Screwdriver

•3/8” Nut Driver

•Screws (2) and Anchors (2) for Anti-tip Bracket (Style will vary depending on mounting surface)

•Pipe Wrench (2)

•Teflon® Tape** or Pipe Joint Compound (Appropriate for use with LP gas and Natural gas)

•Channel Lock Pliers

•Gas Leak Test Solution

•Level

•Drill and Drill Bit

•Gas Supply Line (Flexible Metal Appliance Connector or Rigid Pipe)

•Gas Shut Off Valve (If not already present)

•Gloves and Safety Goggles

*Not required for Canadian Installations.

**Teflon is a registered trademark of DuPont.

WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.

−Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

−WHAT TO DO IF YOU SMELL GAS:

•Do not try to light any appliance.

•Do not touch any electrical switch.

•Do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

−Installation and service must be performed by a qualified installer, authorized service agency or the gas supplier.

WARNING

Do not repair or replace any part of the appliance unless specifically recommended in the manuals. Improper installation, service or maintenance can cause injury or property damage. Refer to this manual for guidance. All other servicing should be done by a qualifiedtechnician.

For Massachusetts Installations:

1.Installation must be performed by a qualified or licensed contractor, plumber or gas fitter qualified or licensed by the state, province or region where this appliance is being installed.

2.Shut-off valve must be a “T” handle gas cock.

3.Flexible gas connector must not be longer than 36 inches.

WARNING

RANGE TIPPING HAZARD

•All ranges can tip and injury could result. To prevent accidental tipping of the range, attach it to the wall, floor or cabinet by installing the Anti-Tip Device supplied.

•A risk of tip-over may exist if the appliance is not installed in accordance with these instructions.

•If the range is pulled away from the wall for cleaning, service, or any other reason, ensure that the Anti-Tip Device is properly reengaged when the range is pushed back against the wall. In the event of abnormal usage (such as a person standing, sitting, or leaning on an open door), failure to take this precaution could result in tipping of the range. Personal injury might result from spilled hot liquids or from the range itself.

English • 1

Preparation Installation

Final Steps Service